CMP Panther KPS25A User manual
Introduction
Thank you for purchasing your new KingPin Anchor system. Please read through these operating
instructions so you will know how to install and operate your model properly.
Safety Precautions
The safety precautions for this KingPin Anchor system have been pre-pared to assist the operator in
the performance of good safety procedures.
Warning!!
Only engage KingPin Anchor pole when stopped. NEVER MOVING. Disengage KingPin Anchor pole
before moving the watercraft. ALWAYS be aware of your surrounding while moving with KingPin
Anchor pole in its mount. Take CAUTION around bridges, low hanging trees, power lines, Etc. Make
sure KingPin Anchor pole is securely stored before trailering boat. Always use the comfort grips while
handing the KingPin Anchor pole. Never step on the KingPin Anchor mount. Take CAUTION articles of
clothing could get snagged on the KingPin Anchor mount.. Use caution while docking with KingPin
Anchor mount attached to watercraft. FAILURE TO HEED TO ANY OF THESE INSTRUCTIONS MAY
RESULT IN DAMAGE TO YOUR KINGPIN ANCHOR SYSTEM, WATERCRAFT, AND/OR SERIOUS
PERSONAL INJURY OR DEATH.
Kit Includes
One (1) 2.5" or 5" or 10" Transom Four (4) 5/8” O-Rings Four (4) Screws
*Note: Kit does not include the (2) Rubber Pole Clips shown below.
(Included with the Pole Kit only.)
Base Plate
Screws
5/8” O-Rings
Watercraft
13/64 Drill Holes
Required Tools For Installation
• 13/64” Drill Bit
• Phillips Bit
• Power Drill
• Marker
Installing the KingPin Anchor
1. First use the base of the anchor as a template for marking hole location.
2. Drill holes using a 13/64” drill.
3. Place 5/8”O-Rings in countersink grooves on the boat side of Base Plate.
4. Align and secure anchor with machine screws. CAUTION over tightening may cause screws
to strip.
The hardware installation is complete. Your KingPin Anchor is ready for use.
Learn more about anchors and docking on our website.
This manual suits for next models
8
Table of contents
