Page 1 of 2
Failure to install or use this product according to manufacturer’s recommendations may result in property damage, serious bodily/personal injury,
and/or death to you and those you are seeking to protect!
WARNING!
1. Proper installation combined with operator training in the use, care, and maintenance of safety products are essential to ensure the safety of
you and those you are trying to protect.
2. Exercise caution when working with live electrical connections.
3. This product must be properly grounded. Inadequate grounding and/or shorting of electrical connections can cause high current arcing, which
can cause personal injury and/or severe vehicle damage, including re.
4. Proper placement and installation are vital to the performance of this safety product. Install this product so that the performance of the system
is maximized and the controls are placed within convenient reach of the operator so that s/he can operate the system without losing eye contact
with the roadway.
5. It is the responsibility of the vehicle operator to ensure during use that all features of this product work correctly. In use, the vehicle operator
should ensure the eld-of-view of the camera/monitor is not blocked by vehicle components (i.e., open trunks or compartment doors), people,
vehicles, or other obstructions.
6. Never take the right-of-way for granted. It is your responsibility to be sure you can proceed safely before entering an intersection, driving
against trafc, responding at a high rate of speed, walking on or around trafc lanes.
7. This equipment is intended for use by authorized personnel only. The user is responsible for understanding and obeying all laws regarding
safety products. Therefore, the user should check all applicable city, state, and federal laws and regulations. The manufacturer assumes no
liability for any loss resulting from the use of this safety product.
Do not install and/or operate this safety product unless you have read and understand the safety information
contained
Specications:
Battery Capacity 3.6V/6700mAh
Charging Voltage DC 5-12V
Charging Time 5V/8 hrs, 12V/3hrs
Discharging Time 12 continuous hours
Charging Temperature -10 TO 45°C
Waterproof Rating IP69K
Image Device 1/3” CMOS PC3089
TV System PAL, NTSC
Effective Pixels 756 x 504 Pixels
Sensing Area 4.80mm x 3.73mm
Scanning System 2:1 Interlace
Sync System Internal
Operation Frequency 2400-2483.5 MHz
Line of Sight Range 120m
Delay 120 m/s
Night Vision Distance 8 to 10 meters
Audio Yes
Viewing Angle 120°
IR-Cut Yes
Standby Mode 30 seconds of inactivity
Magnetic Strength 60 lbs
Using the CC7008-WM monitor:
1. Press S to enter the single image mode and image number to be paired.
2. Press M to enter the Menu.
3. Use the + or - to highlight the PAIRING Option.
4. Press the down arrow to enter the PAIRING Option.
5. The monitor will display the message “PAIRING START 50” and a counter
that counts down 50 seconds. Power on the camera within the rst 45
seconds.
6. The camera will pair with the monitor after 5-8 seconds.
Using CC7008-WM remote:
1. Press SEL to enter the single image mode and image number to be paired.
2. Press PAIR to enter the PAIRING OPTION.
3. The monitor will display the message “PAIRING START 50” and a counter
that counts down 50 seconds. Power on the camera within the rst 45
seconds.
4. The camera will pair with the monitor after 5-8 seconds.
0%-25%
25%-50%
50%-75%
25%-50%
ON/OFF
FIGURE 1
Pairing Instructions:
Operating Instructions
CC2030-WC Wireless Camera
