Dash GUARDIAN User manual

About the Guide
Step 1 Use the guide to mark & drill holes for the drywall anchors.
Step 2 Attach the mounting plate by drilling the provided screws
into the anchors from step 1.
Step 3 Attach the camera to the magnetic mounting plate,
and adjust lens as needed.
Step 1
Step 3
Connect the camera to a power source.
Scan the QR code or search “IC Realtime” in the Google Play
or App Store to download and install DASH App.
Step 5
Step 4
With your mobile device connected to a 2.4 GHz band, add a
camera by following the steps depicted below.
Run the DASH App, and then register a new account if you
do not already have one.
Step 2
The camera LED indicator will flash green when it is fully booted on.
Note:
Note:
If camera fails to to add or the WiFi connection is
changed. Reset the camera and repeat step 5.
Repeat step 5 for adding multiple cameras.
Mounting Surface
Hole Guide
Drywall Anchors
Mounting Plate
Self-tapping Screw
Camera
Make sure the mounting surface can hold at least 1lb.
This quick start guide is for reference only. Minor
difference might be found in user interface.
All the design and software here are subject to
change without prior written notice.
All trademarks & registered trademarks mentioned
are the properties of their respective owners.
Please visit our website or contact your local
service engineer for more information.
If there is any uncertainty or controversy, please
refer to our final explanation.
-
-
-
-
-
Using the Dash App Camera Installation

Note: Press and hold the
reset button for 10 s to reset the camera.
The pattern of the LED indicator is included in the following table.
LED Indicator Status
Green light flashing
Red light flashing
Green and Red light
flashing alternately
Green light on
Powered off/LED turned off
Rebooting after reset
Booting
Device malfunction
Waiting for network
Operating properly
Network connection failed
Off
Red light on
Firmware updating
Camera ×1
What’s in the Box Know your Guardian
Power Adapter ×1
QSG ×1
Mounting Plate ×1
Power Cable ×1
Hole Guide ×1
Hardware Package ×1
Weather Foam Seal ×1
LED Indicator
Lens
Built-in Mic
Micro SD
Card Slot Built-in
Speaker
Reset Button
Power Port
GUARDIAN