Colebrook Bosson Saunders AV/VC One User manual

REFER ALSO TO MAIN
INSTRUCTIONS FOR AV/VC
ONE STAND INSTALLATION
Installation Instructions for
AV/VC One Full Front Panel
PRODUCT CODE: AVS/021/PAN1
AV/VC One - Full Front Panel
5KG/11 LBS
Handle with care
AVS/021/PAN1
AVS-021-PAN1-INST-A-MAY 2016
WARNING
• Correct installation is essential to safe and reliable operation of the
AV/VC One product and falls outside the scope of responsibility
of Colebrook Bosson Saunders. Please follow assembly instructions carefully.
• Do not use this product for any purpose other than that for which it
was designed.
• Ensure that oor or wall surface is strong enough to support the weight of
the fully-loaded AV/VC One and that the oor surface is at and level.
• Do not install AV/VC One outdoors or in environments where it will be
directly exposed to moisture or highwinds.
• Follow the manufacturer’s guidance for mounting of monitors, displays
and other equipment.
• Please take care to avoid trapping ngers when installing or adjusting
the product.
ELECTRICAL SAFETY
• Safe installation of electrical equipment is the responsibility of the installer.
• Colebrook Bosson Saunders recommends that only double-insulated
electrical equipment and cables are installed in AV/VC One unit.
MAINTENANCE AND INSPECTION
• Ensure all screws and xings are fully tightened and occasionally re-tighten if necessary.
• Clean with a dampcloth. DO NOT use solvents.
DISCLAIMER
As part of Colebrook Bosson Saunders ongoing product improvement
programme, the design of products may change without prior notice and
details may vary from those illustrated.

1.1
1.3
1.2
Install front panel to column 1
IMPORTANT NOTE
Ensure mount hooks are
fully engaged
PLEASE CONSIDER LEAVINg ThESE INSTRUCTIONS wITh ThE UNIT
IF FURThER INSTALLATION MAY bE REqUIRED bY OThERS
INSTALLATION IS NOW COMPLETE