Comarch Quarantine Warden User manual

User’s guide
Quarantine Warden

2 3
Table of contents
1. Introduction ____________________________________3
2. Charging of the Band _____________________________4
3. Turning the Band on ______________________________5
4. Answering a call _________________________________6
5. Ending a call ____________________________________6
6. Additional information on using of the device _________6
7. Voice messages in the Band _______________________7
8. Cautions _______________________________________7
9. Utilization ______________________________________8
10.Technical specifications___________________________8
11. Terms of use ____________________________________9
12.Contact ________________________________________9
13.Date of issue or last update of the user’s guide _______9
1. Introduction
The Quarantine Warden is a comprehensive solution
for remote monitoring of people quarantined during the
coronavirus (COVID-19) pandemic. It provides the ability
to make voice calls and has an integrated GPS module,
which enables the wearer to quickly contact with ser-
vices, get medical assistance and allows information
to be passed to the relevant services about a person
leaving the designated area in the event of attempts to
break a quarantine order.
The set includes:
•Band
•Charger
•User’s guide
Contact button
Contact button
On/Off Button
Light

4 5
2. Charging of the Band
To charge the device:
1. Connect the charger to a power source.
2. Place the charging socket of the Band on the
magnetic connector of the charger.
a. Charging of the Band is signalled by a flashing
red light and a voice message about charging
the device.
b. When the device is fully charged, the red light
stops flashing and the green light turns on.
When the device is fully charged:
1. Disconnect the charging socket of the Band from
the magnetic connector of the charger.
2. Disconnect the charger from the power source.
3. Turning the Band on
To turn the Band on:
1. Press and hold the green button for 3 seconds.
2. While holding the button, wait until the green light
is on and the tune and voice message are played.
Connector Charging socket
Light
On/Off Button

6 7
4. Answering a call
To answer a call from the government services, press
the green button on the Band.
5. Ending a call
To end the call, press the green button on the Band.
6. Additional information on using of the
device
When the yellow button of the Band is briefly pressed,
the current time and number of steps taken are read off.
7. Voice messages in the Band
Information about the device status is provided by voice
messages played by the Band.
Status Voice message
Turning the Band on “The device powered on
successfully”
Charging of the Band “The device is charging”
8. Cautions
•Use only the charger included in the kit to
charge the Band.
•Do not unscrew the Band under any circum-
stances.
•In the event of a device malfunction or me-
chanical damage, please contact the govern-
ment services.
Answer or End Button

8 9
9. Utilization
The user of the Band is not authorized to uti-
lize it. When the operating period is over, for
environmental reasons, it will be separately dis-
posed of by a government services represent-
ative, in accordance with applicable directives
and standards for electronic devices. The device
contains a lithium-polymer battery (Li-poly).
10. Technical specifications
Parameter Value
Band material TPU
Radio interfaces GSM 900/1800
Power Lithium polymer battery,
450 mAh
Charger type Magnetic charger
Microphone/Speaker Built-in
International Protection Rating IP67
11. Terms of use
Ambient temperature: -20 – 55°C
Relative humidity: <80%
Air pressure range: 860 – 1060 hPa
12. Date of issue or last update of the user’s guide
Version: 0.3
Date: 2020.04.06
Made in PRC

PO Box 5674 Abu Dhabi, United Arab Emirates
+ 971 2 4493333 + 971 2 4449822
www.doh.gov.ae