Comet Antenna CST-30 User manual

Connector mount bracket
【 Features 】
● This is a connector mount base for direct mounting of ICOM IC-705 radio and
YAESU FT-817ND, FT-818ND.
● The angle can be changed to match the installation angle of the radio.
● BNC-LP, SO-239 Adapter cable is included.
● Holes are provided for SMA-J and BNC-J bulkhead types to be mounted.
MODEL CST-30
Notes on installation and installation
!
■Tighten all screws securely to prevent unexpected tipping or falling off.
■An antenna that is too long may not be able to hold its angle due to poor balance.
Make sure that the antenna can withstand the installation before installing it.
[How to use]
Refer to the figure below for installation.
When attaching the bracket to YAESU FT-817ND, FT-818ND, it will be easier to
attach the cable if the upper bracket direction is opposite.
Product Specifications
Bracket dimensions : 53(W) x 32(D) x 68(H) [mm]
Bracket weight : approx. 70g
Material : SUS304 [Main body], Brass [Screw]
BNC-LP to SO-239 Adapter cable
Cable length : approx. 130mm
Instruction Manual
Thank you for purchasing our products.
For your safety :
Read this manual carefully for proper handling and operation before using.
Keep this manual in a safe place for future reference.
For installation on ICOM IC-705
For installation on YAESU FT-817ND,FT-818ND
Screws for fixing to the
enclosure are not included.
Turn the IC-705 in the
opposite direction from
when it was installed.
Only one knurled knob is used.
Accessories:
■ 2 screws with knurled knobs
■ BNC-LP to SO-239 Adapter Cable
IC-705 GND terminal

1st edition. Jan 2021. Printed in JAPAN.
Copyright (C) 2021 COMET CO.,LTD. All Rights Reserved.
【 Inspection and care 】
Check the mounting screws and brackets regularly for looseness, and retighten any loose parts.
Be sure to replace parts that have become insufficient or deformed due to changes over time.
■ Specifications or appearance is subject to change without notice.
COMET CO.,LTD.
4-18-2, Tsuji, Minami-ku, Saitama-shi, Saitama-Pref, 336-0026, JAPAN
TEL : [phone] / FAX : [phone]
URL : http://www.comet-ant.co.jp/english
Hole for SMA-J bulkhead
Hole for BNC-J bulkhead
●For connector holes other than SO-239
Holes are provided to accommodate SMA-J and BNC-J
bulkhead connectors.
Notice: Please note that some sizes of BNC-J bulkhead
connectors are not compatible with some manufacturers.
!
● Tighten the screws and nuts securely during installation to prevent a fall accident.
● Install in a place free from vibration and shaking so that the screws do not loosen.
● Pay attention to the weight balance when installing antennas.
Cautions
Assembly image : bracket only
Adapter cable install image : Default position [ 0 degree ]
Adapter cable install image : Inclined position [ Max. 30 degree ]
Hex. Nut
Tooth washer
Gasket
FT-817ND,FT-818ND
Install Image