comfort air CH-V12 Assembly instructions

12/14//16/18 Inch High Velocity Fan
CH-V12/CH-V14/CH-V16/CH-V18
INSTRUCTIONS FOR USEAND CARE
When using electrical appliances, basic safety precautions should always
be followed including the following:
1. Use this fan only as described in this manual, Other use not
recommended may cause fire, electric shock or injury.
2. High Velocity fans are designed to create rapid air movement,
therefore make sure the fan is not placed near drapes, curtains or any
objects that may be drawn into the fan inlet.
3. To protect against electrical shock, do not immerse unit, plug or cord
in water or spray with liquids.
4. This appliance is not intended for use by children or other persons
without assistance or supervision if their physical, sensory or mental
capabilities prevent them from using it safely. Children should be
supervised to ensure that they do not play with the appliance.
5. Unplug the fan from the outlet when not in use, when moving fan
from one location to another, servicing and before cleaning.
6. Do not operate fan in the presence of explosive and/or flammable
fumes.
7. Do not place the fan or any parts near an open flame, cooking or other
heating appliance.
8. Avoid contact with moving fan parts.
9. To disconnect, grip the plug and pull it from the wall outlet, never
yank the cord.
10.Always use on a dry level surface.
11.Do not hang or mount fan on a wall or ceiling.
12.Do not operate the fan without protective front and rear grilles in
position.
13.Be careful not to place the fan too close to the edge of the surface.
14.Do not use outdoors.
15.Do not let the power cord hang over the edge of a table or counter or
let it touch any hot surfaces.

READ AND SAVE THESE
INSTRUCTIONS
WARNING: TO reduce the risk of fire or electrical shock, DO NOT
USE THIS FAN with any SOLID STATE Speed Control Device.
IF the supply cord is damaged, it must be replaced by the
manufacturer or it’s service agent or a similarly qualified person in
order to avoid any hazards.
OPERATION
1. Tighten the front guard to rear guard with screw and nut provided.
2. Set your fan on a level dry surface.
3. Plug the power cord into a standard 120 Vac wall outlet.
4. To operate your fan, turn the control knob to the desired fan speed low
(I),Med(II) high (III)
5. Adjust the fan head to your desired angle.
CARE AND STORAGE
1. Turn the control to OFF and UNPLUG THE FAN BEFORE
CLEANING.
2. Use only a soft damp cloth to clean the fan.
3. DO NOT immerse the fan in water and never allow water to drip into
the motor housing.
4. Do not use gasoline, paint thinner or other chemicals to clean the fan.
5. Store the fan in its original box or cover the fan to protect it from dust.
Store it in a cool dry place.