
3
3
ASSEMBLY INSTRUCTIONS:
1. Loosen large cover cap and slide it up and out
of the way while you assemble the base (Fig. 1).
2. Slide each of the four feet into the grooves.
If necessary, gently tap the feet into place
with a rubber mallet (Fig. 2).
3. Slide the Large Cover cap back down and screw
into place by rotating until it feels tight (Fig. 3).
4. Loosen the xed screw to lengthen pole to
desired height. Once pole is at desired height,
screw the xed screw in to place by rotating it
until it is tight (Fig. 4).
5. To mount heater CZPH10 and CZPH10R to stand,
please assemble hardware to heater per the
instructions provided in the heater manual. Once
hardware is assembled to heater, the xed axle (#8 on
stand diagram) can be threaded through the heater
hardware and turning knobs tightened, to keep the
heater securely mounted to the stand (Fig. 5).
6. To mount heater CZPH20RSL to stand, please
assemble hardware to heater per the instructions
provided in the heater manual. Once hardware is
assembled to heater, the 2 xed axle screws can be
threaded through the heater hardware and buttery
nuts tightened, to keep the heater securely
mounted to the stand (Fig. 6).
CAUTION: Please keep Comfort Zone® Outdoor/Indoor
Electric Patio Heaters at a horizontal angle when mounted
to the stand. For safety, the heater should not be mounted
vertically or diagonally. See heater Instruction Manual for
safety precautions.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
43in - 71in