CommScope NETpodium 1-1671578-1 User manual

NETpodium Side Panels (1-1671578-1/1- 1671578-2)
INSTRUCTION SHEET411 -117006Jan 2017 REV B
1. Kit content
Bac k side panel 1 pc
Front side panel 1 pc
Assembly hardware
2. Mounting a Tool-less Fastener (TF)
2.1. The profile
2.2. How to install a TF
Insert the TF into the T-channel.
Quarter turn clockwise.
TF is ASSEMBLED in the T-channel, you can still slide it to
choose it’s position.
TF is FIXED, you can NOT slide it.
3. Install the Back Side Panel
Insert a TF in the outer T-channel (see paragraph 2.2) of each
NETpodium back prole at the height of 1078mm measured from
the top surface of the NETpodium bottom prole.
Pay attention to the following:
The side panel must be positioned in front of the installed bracket.
The lock must be positioned as shown on the picture.
T-Channel
Groove
P ositioning bracket,
located at the BOTTOM
of the side panel.
P ositioning brackets,
located at the SIDE of
the side panel.
1078mm

NETpodium Side Panels (1-1671578-1/1- 1671578-2)
INSTRUCTION SHEET411 -117006Jan 2017 REV B
Place the positioning bracket at the bottom of the side panel in
the horizontal groove of the NETpodium prole.
Slide the side panelto the front and insert the positioning
brackets on the side of the side panel into the vertical groove of
the NETpodium prole.
Use an Allan key n°5 with conical head to x the side panel with
screws and washers (torque of 3.5-4Nm).
Rotate the lock in the middle of the side panel to x it,
the already assembled TF is used the xthe side panel.
4. Install the Front Side Panel
Place the positioning bracket at the bottom of the side panel in
the horizontal groove of the NETpodium prole.
Pay attention to the following:
The side panel must be positioned in front of the installed bracket.

NETpodium Side Panels (1-1671578-1/1- 1671578-2)
INSTRUCTION SHEET411 -117006Jan 2017 REV B
This product is covered by one or more U.S. patents or their foreign equivalents. For patents see, www.commscope.com/ProductPatent/ProductPatent.aspx
To obtain more information on CommScope® products, visit our website at http://www.commscope.com/SupportCenter/TechnicalSupport.aspx
©20 17 CommScope,Inc.
All Rights Reserved
Contactus:
Technical Support
Technical Assistance Center (TAC)
Greensboro, North Carolina
www.commscope.com
Tel : [phone]
Email: [email protected]
www.commscope.com/SupportCenter/TechnicalSupport.aspx
Slide the side panelto the back and insert the positioning
brackets on the side of the side panel into the vertical groove of
the NETpodium prole.
Use an Allan key n°5 with conical head to x the side panel with
screws and washers (torque of 3.5-4Nm).