Communica UNI REMOTE TX4H 433MHZ BLUE User manual

TX4 14710131619ROSSI258111417MDEA MIO TR2otorLine MX4SP DSMPeccinin TX3C Centurion NOVA AN MOTOR AT-4FADINI JUBI369121518Chipset compatible with most 433Mhz remotes.
Fixed and Rolling Code.
Compatible with the following:
Remote Control DuplicatorUser's Manual BFT MITTO2 MITTO4 (old version)FAAC XT4 433RC KEY TXB-42R ATA PTX4 GBD AU1600 Nice-Smilo NOVOFERMHilandNICE FLORSV2 BENINCA TO GO WV DOORHANUNI REMOTE TX4H 433MHZ BLUE

UNI REMOTE TX4H 433MHZ BLUE
Programming Fixed Code (Learn Method )
MEMORY CLEARANCE
1.PRESS BUTTON 1 AND 2 SIMULTANEOUS UNTIL LED FLASHES 3 TIMES
2. RELEASE BUTTON 2 (KEEP PRESSING BUTTON 1), AND PRESS BUTTON 2 SLOWLY FOR 3 TIMES, LED
FLASHES QUICKLY.
3. RELEASE BOTH BUTTON, THE DUPLICATOR IS READY FOR COPYING
DUPLICATING
PUT DUPLICATOR ASIDE OF ORIGINAL TRANSMITTER, AS CLOSE AS POSSIBLE.
PRESS AND HOLD BUTTON 1 OF ORIGINAL TRANSMITTER, THEN PRESS AND HOLD BUTTON 1 OF
DUPLICATOR UNTIL YOU SEE THE DUPLICATOR’S
LED FLASHES MEANS THE DUPLICATING SUCCEED.
REPEAT ABOVE STEP TO THE REST BUTTONS. THE DUPLICATOR WILL WORK AFTER DUPLICATING.
FIXED CODE REMOTE CONTROL:
PRESS AND HOLD BUTTON 1 OF ORIGINAL TRANSMITTER, THEN PRESS AND HOLD BUTTON 1 OF
DUPLICATOR UNTIL YOU SEE THE DUPLICATOR’S
LED FLASHES MEANS THE DUPLICATING HAS SUCCEED.
ONCE 1 BUTTON DUPLICATED, THE REST BUTTONS WILL GENERATE AUTOMATICALLY, PLEASE
FOLLOW ORIGINAL RECEIVER MANUAL TO INSERT
THE NEW DUPLICATOR ON THE RECEIVER.

PROGRAMMING ROLLING CODE REMOTE CONTROLS :
1, MEMORY CLEARANCE
2, PRESS AND HOLD BUTTON 1 OF DUPLICATOR TILL LED FLASHES TWICE AND OFF, PRESS BUTTON 2
ONCE WHILE KEEP HOLDING BUTTON 1,
THE DUPLICATOR INTO BFT COPYING MODE
3,PRESS AND HOLD BUTTON 1ST &2ND OF BFT SIMULTANEOUS (SEED CODE SENDING MODE), LED
ON DUPLICATOR WILL FLASHES TWICE
AND OFF, RELEASE BOTH BFT BUTTONS AND THEN PRESS ANY BUTTON OF BFT, LED ON DUPLICATOR
WILL FLASHES THREE TIMES THEN STAY
ON, WHICH INDICATES BFT COPYING DONE.
REMARKS: BUTTON 1 OF DUPLICATOR KEEP PRESSED FROM STEP 2 TILL 3 DONE.
DUPLICATOR TO SEND SEED CODE OF BFT: PRESS BUTTON 1 & 4 SIMULTANEOUS.
SPECIAL PROGRAMMING STEPS FOR BFT MITTO2 & MITTO4 (OLD VERSION)
IF YOU ERASE THE CODE BY MISTAKE, YOU CAN RESUME IT BY PRESSING AND HOLD BOTH OF THE
"3" AND "4" BUTTON ON THE REMOTE
CONTROLLERS AT THE SAME TIME, AFTER 10 SECONDS, THE LED FLASHES 2 TIMES AND TURN OFF
WHICH INDICATES THE CODE OF THE COPY
REMOTE CONTROLLER IS RESUMED.
RESUME
REMARKS
FOR FIXED CODE &LEARNING CODE REMOTE CONTROLS, THE DUPLICATOR WILL WORK AFTER
DUPLICATING.
BUT FOR THE ROLLING CODE BRAND LISTED ABOVE, PLEASE FOLLOW THE ORIGINAL MANUAL TO
PROGRAM THE DUPLICATOR TO RECEIVER AFTER DUPLICATING.