Drywall/Metal Stud Installation
1a. Locate stud and mark centre of studs on the wall
with a pencil
1b. Place wall plate at your desired height and position
over your studs. Level wall plate and mark hole on
the wall
2. Drill four holes to a depth of 1 in. (26 mm), using a
1/2 in. (13 mm.) diameter drill bit
4. Hold the plastic straps by the end and pull towards
you until the metal channel is ush behind the wall.
5. Hold ends of straps together between thumb
& forenger and pull toward you untill channel rests
behind wall. Ratchet cap along straps with other
hand until ange of cap is ush with wall.
6. Bend the straps side to side until they snap o level
with the ange of the cap.
3. Insert wall anchors by folding metal channel until it
is at with the plastic straps. Slide the metal channel
into the drilled hole.
7. Install the wall plate using four screws Q and washers
R. Tighten all screws Q only until they are pulled
rmly against the wall plate.
Once wall mount is secured, proceed to main
instructions to mount TV.
1/4 in × 2 in
1/4 in
1/2” Drill Bit
P
P
R
Q
12
3 3b
45
6 7
1 in
(25 mm)
1/2 in
(13 mm)
For narrow stud
Angle the drill at 650angle the wall anchor
Single Stud Mounting Option Drywall Mounting Option
R
QR
Q
1/4 in hollow wall anchor
SQ
R
DO NOT MOUNT TV MOUNTS WITH ARMS TO DRYWALL.
SWIVELING MOUNTS HAVE TO BE MOUNTED TO STUDS.
