Connects2 CTUSK02-AMP User manual

www.connects2.com
INSTRUCTION MANUAL
CTUSK02-AMP
INFODAPTER

www.connects2.com
2
ABOUT
The Connects2 Infodapter for Skoda MIB platform vehicles allows vehicle information
such as climate control, parking sensors and heated seats to be displayed on any
aftermarket head unit with rear camera input. The Infodapter also allows the use of the
steering wheel controls with almost every steering wheel control compatible head unit on
the market and also retains the OEM Canton amplier.
DIP SWITCH SETTINGS
See Fig 1.
Up = Off, Down = On
1: On = Pioneer head units. Off = All other head units
2: Setting for reverse camera. On = PAL, Off = NTSC. The default setting is Off (NTSC).
3: Resets the display settings back to default. If the display settings have been
manipulated in a way that it is no longer possible to make adjustments, change the
DIP switch #3 from Off to On and back. This will reset the screen settings to the factory
defaults. During this procedure the screen background will change to red. While the
background is red, no settings can be made.
4: Not applicable. (This should be kept in the Up/Off position)
Interface Connections
Fig 1.
1 234
DIP ON
Reverse Camera output
to head unit and reverse
camera input from
optional camera
Power Harness Steering Wheel
Remote control
connector to
head unit
Dip Switches Not Used
Aftermarket Head Unit
Reverse Camera Input
Reverse Camera
(Optional)
To Car Connector
(SKODA MULTIMEDIA
Speaker Level In Steering Wheel
Control Input Infodapter Interface
Amp Retention
Interface
From MOST Audio Fibre Cable
(SKODA MULTIMEDIA)
MOST Audio Out
(Remove Grey
Protective Cover)
Park Brake (Green)
Amp Remote (Blue)
Mute (Grey)
Speed Pulse (Pink)
Reverse (Purple)
To Fascia Panel Buttons (See Fig.3)
SKODA MULTIMEDIA

www.connects2.com
3
Facia/Steering Wheel Controls
Conguration Menu
To access the menu, push the ‘MENU’ button on the fascia panel (Fig.3) and use the UP
and DOWN buttons to navigate. Use the OK button to select and Back to go back or exit.
The Car button will allow access to the vehicle trip computer.
Conguration Menu
Vehicle Settings
Infodapter Settings
Language
Version
< Back
Vehicle Settings
ESC System
Tyre
Driver Assistance
Parking and Manoeuvering
Light
Mirrors and Wipers
• Vehicle Settings
Vehicle settings can be adjusted via
the menu. All vehicle setup options
that were available with the original
head unit, are now available through
the aftermarket head unit. See the
vehicle handbook for more information
regarding these features.
Screen Size/Position
Horizontal Size
Horizontal Position
Vertical Size
Vertical Position
< Back
• Infodapter Settings
o Screen Size/Position -
Make sure all 4 corner markers
are touching the corners of
the aftermarket head unit
display. Note that you may
need to adjust the screen size/
position to avoid any warning
messages displayed on the
aftermarket head unit.
Fig 3*.
* Shown here are both available facia types

www.connects2.com
4
Conguration Menu...continued
Preferences
Driver Position Right
Camera Connected Yes
Reverse Priority Park Assist
Park Brake Source Speed
Climate 5S
Restore factory settings
< Back
o Preferences -
Driver Position - Select Left or Right depending
upon vehicle conguration.
Camera Connected - Select Yes if an optional
camera is connected.
Reverse Priority* - Select which image (Camera
or Park Assist) will be shown by default when
reversing. The driver can select the desired
image by pushing the Source button (Fig.3)
while reversing. (*Note this option is only
available when Camera Connected is set to
Yes)
Park Brake Source - Set to Speed, Brake or
Always On.
Climate - Select how long the climate display
should be shown on the head unit when ad-
justed. Select between the range of 3 seconds
and 30 seconds.
Restore factory settings - Reverts all
Infodapter settings to factory defaults.
(This does not restore vehicle settings)
Infodapter Settings
Screen Size/Position
Picture Settings
Preferences
<Back
o Picture Settings -
Adjust Brightness, contrast and
colour saturation.
Legal Information
Please consult the relevant road trafc laws governing the country in which this product is being operated.
No liability is accepted for material damage, loss or personal injury, directly or indirectly, from installation and
operation of this product. This product should only be operated when safe to do so.
o Driving Mode -
The driving mode button can be
used as normal. The graphic for the
mode will be shown on the head
unit.
o Park Assist -
The park assist button can be used
as normal to activate/decactivate
park assist. The graphic will be
shown on the head unit.