Contempocat Concealer Cabinet User manual

Install “back support bar” and “top panel”
Concealer Cabinet
-For Litter-Robot-3 “Open Air”
-Assembly Instructions
What s In The Box?
The following components are included in your package:
● Left and Right Side Panels
● Top Panel
● Back Panel (1/8” thick hardboard)
● Back support bar
● Alignment Guide
● (8) decorative hex-head screws
● (8) 5/8” long phillips-head screws
● (1) hex key
Let s Get Started!
We recommend TWO (2) people for assembly of this item.
1
a) Position left/right panels “face down” as
shown, making sure the 2 pilot holes in the long
edge of the support bar are facing down and
the 3 pilot holes (dashed arrows) in the support
bar are facing outward.
Secure the support bar with two decorative
screws.
b) Flip cabinet upright. Making sure the routed
lip is facing downwards and towards the back,
carefully slide the top panel into the grooves in
the sides until the back is flush with the side
panels.
c) Secure with 4 decorative screws.

Flip cabinet upright and place it where you like!
3
Install “back panel” and “alignment guide”
2
NOTE: The “smooth” side of the back panel
should face the interior of the cabinet.
a) Flip cabinet face down. Observe the hole
pattern in the back panel. Along one short side,
there are 3 holes in a straight line (2 in. from
edge), which correspond to the pilot holes in the
support bar.
b) Place the back panel in the routed recess in
the cabinet so that all holes line up with the pilot
holes in the cabinet.
c) Secure with the (8) x 5/8” long screws using
a phillips screwdriver.
d) Locate the pilot holes on the underside of
the support bar and attach the Alignment Guide
as shown using the final 2 decorative screws.
Tips:
The “Alignment Guide” will slide into the slot on
the underside of the Litter-Robot and contact the
black “pressure foot”. It s job is to keep the Litter-
Robot from touching the back of the cabinet as it
tilts back slightly when your cat enters.
When sliding the Litter Robot into the cabinet,
keep it as centered and “square” with the cabinet
as you can until it contacts the alignment guide.