3Instruction manual |BDA 681
CONTRIK IPower Strip XO ICCV5RD*
3. Safety instructions
Read the operating instructions
carefully and observe the safety
instructions in particular.
If you do not follow the safety
instructions and the information on
proper handling in this operating
manual, we will not accept any
liability for any resulting personal
injury/property damage.
In addition, the warranty/guarantee
will be voided in such cases.
This symbol means: Read the
operating instructions.
• The product is not a toy. Keep it away from
children and pets.
• To avoid clamping injuries and burns at high
ambient temperatures, it is recommended to wear
safety gloves.
• It voids the warranty, in case of manual
modifications of the device.
• Protect the product from extreme temperatures,
direct sunlight, strong vibrations, high humidity,
strong jets of water, falling objects, flammable
gases, vapors and solvents.
• Do not subject the product to very high mechanical
stress.
• If safe operation is no longer possible, take the
product out of operation and protect it from
unintended use. Safe operation is no longer
guaranteed if the product:
shows visible damage,
no longer functions properly,
has been stored under unfavorable
environmental conditions for an extended period
of time, or
has been subjected to considerable transport
stresses.
• Handle the product with care. The product may be
damaged by shocks, impacts or dropping.
• Also observe the safety instructions and operating
instructions of the other devices that are connected
to the product.
• There are parts inside the product that are under
high electrical voltage. Never remove covers.
There are no user-serviceable parts inside the unit.
• Never plug in or unplug power plugs with wet
hands.
• Only use a proper 5-pole CEE mains plug removed
by a qualified electrician as the voltage source.
• 5-pin CEE mains socket (400 V/AC, 50 Hz).
• When supplying power to the device, make sure
that the cable cross-section of the connecting
cable is sufficiently dimensioned according to local
norms.
• Never connect the product to the power supply
immediately after it has been moved from a cold
room to a warm room (e.g. during transport). The
resulting condensation water can possibly destroy
the device or lead to an electric shock! Allow the
product to come to room temperature first.
• Wait until the condensation water has evaporated,
this may take several hours. Only then may the
product be connected to the power supply and
put into operation.
• Do not overload the product. Observe the
connected load in the technical data.
• Do not operate the product covered! At higher
connected loads, the product heats up, which
can lead to overheating and possibly fire when
covered.
• The product is only de-energized when the mains
plug is pulled out.
• Make sure that the product is de-energized before
connecting a device to it.
• The mains plug must be disconnected from the
socket under the following conditions:
before cleaning the product
during thunderstorms
when the product will not be used for an
extended period of time.
Never pour liquids on or near the product.
There is a high risk of fire or fatal electric shock.
If liquid should nevertheless get inside the device,
immediately switch off all poles of the CEE mains
socket to which the product is connected (switch
off fuse/automatic circuit breaker/FI circuit breaker
of the associated circuit). Only then disconnect the
mains plug of the product from the mains socket
and contact a qualified person. Do not operate the
product any longer.
In commercial facilities, observe the
local accident prevention regulations.
For Germany:
German Federation of Institutions for Statutory
Accident Insurance and Prevention (Verband
der gewerblichen Berufsgenossenschaften) for
electrical systems and equipment. In schools,
training centers, hobby and do-it-yourself
workshops, the handling of electrical equipment
must be supervised by trained personnel.
