ControlByWeb X-432 User manual

See users manual for setup instructions:
www.ControlByWeb.com/support/
| Quick-Start Guide
X-432
Rev 1.0
1. Power the module and connect to network.
2. Set IP address on computer to be on the same network as
the module. (Example: Set computer to 192.168.1.50)
3. To configure the module, open a web browser and enter:
http://192.168.1.2/setup.html
4. Assign permanent IP address to module, then restart module.
5. Restore computer’s IP address, if necessary, and access the
module at its new IP address to finish setup.
Basic Setup Steps
IP Address: 192.168.1.2
Subnet Mask: 255.255.255.0
Control Page Web Address: http://192.168.1.2
Control Password: (no password set)
Setup Page Web Address: http://192.168.1.2/setup.html
Setup Username: admin
Setup Password: webrelay (all lower case)
Factory Default Settings

1681 West 2960 South, Nibley, UT 84321, USA
| Pinout Diagram
X-432
Input -
Input +
3K
Relay A
Relay B
Opto
Isolator
Relay
+5VRef
AinX
AGnd
5V REF
12-Bit
A/D
1K
Power
Supply
Vin+
Vin-
EGnd
+5VOut
Digital Input 17
Digital Input 18
+5V
+5V Gnd
Data
X16
X16
Power Supply In (9-28VDC)
Power Supply In (Ground)