Quick Start Guide
2RFID ANTENNA CONNECTION: Connect RFID
antenna with wrench (8mm torque with 100 N-cm)
to reader (CS463 has 4 available RFID antenna ports
from port 1 to port 4).
WIFI + BLUETOOTH ANTENNA: Connect two
Wi Fi/BT antennas to reader as shown below.
3
ETHERNET CABLE: Connect Ethernet cable
to reader as below.
CS463 is set to Ethernet Static IP of 192.168.25.160 ex-factory. Wi Fi is
disabled ex-factory. This is to simplify the out-of-box experience.
4
WiFi Antenna
BT Antenna
Connecting to CS463 using Browser
Set your PC to a static IP of 192.168.25.100 (or any other as long as
the subnet is 25.
1
Connect Ethernet cable from your PC to CS463 directly, or via an
Ethernet switch.
2
Power up the CS463, wait 2.5 minutes.
3
You will see a User Login page.
Key in User Name: root, Password: csl then click
“Login” to login to the system
5
You will see a Status page.
6
Default Access Mode is HTTP/XML. Change the Access
Mode if reader not in HTTP/XML mode
In order to read and show RFID tags in Web page,
change the Access Mode to “HTTP/XML” as
shown below in the system page.
Click “Set” to confirm the change.
6
Open Google Chrome browser on your PC, and type in 192.168.25.160.
(Note that the Microsoft Edge Browser does not allow numeric based
addressing and therefore cannot be used here. Firefox allows numeric
based addressing. In summary, one can use either Chrome, Internet
Explorer or Firefox).
4
