Coolmed CMPVC12 User manual

1
PORTABLE REFRIGERATOR
CMPVC12
INSTRUCTION MANUAL
For Customer Services & Spare Parts please call 0161 772 5666
Opening times: Monday- Friday 9am-5pm
Or visit us at www.coolmed.co.uk
IMPORTANT:
RETAIN FOR FUTURE REFERENCE

2
For Customer Services & Spare Parts please call 0161 772 5666
Opening times: Monday-Friday 9am-4pm
Or visit us at www.coolmed.co.uk
Contents
Safety Instructions ……………………………………… 3
Installation ……………………………………… 3
Power Supply Preparation ……………………………………… 4
Operating ……………………………………… 4
Usage ……………………………………… 5
Maintenance ……………………………………… 6
Technical Specification ……………………………………… 6

3
For Customer Services & Spare Parts please call 0161 772 5666
Opening times: Monday-Friday 9am-4pm
Or visit us at www.coolmed.co.uk
Safety Instructions
Important note: Please read this booklet before installing and switching on this appliance. The manufacturer
assumes no responsibility for incorrect installation and usage as described in this booklet.
•Do not use mechanical devices or other artificial means to accelerate the defrosting process, such as a
heater or a hair dryer.
•Do not use electrical appliances in the refrigerator compartment of the appliance.
• Do not plug in if the plug or mains cable is damaged.
• If the supply cord is damaged, it must be replaced by a special cord or assembly available from the
manufacturer or its service agent
• Do not pull, twist, or damage the power cable.
• Do not plug-in or un-plug the appliance with wet hands to prevent electrical shock.
•This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction
concerning use of the refrigerator by a person responsible for their safety. Children should be supervised to
ensure that they do not play with the appliance.
•All repairs must be carried out by qualified engineers. Inadequate repairs may be dangerous. Never try to
repair the cooler yourself.
•Do not place explosive or flammable material in the appliance for your own safety.
•Do not allow children to play the packaging, and destroy plastic bags safely.
•There is flammable foam layer material inside the appliance, which should be disposed by qualified recycling
companies.
•Bottles containing a high percentage of alcohol must be sealed well and placed vertically in the refrigerator.
•Do not cover the body of the appliance.
•Do not position the appliance next to a heat source or in direct sunlight.
•Make sure that the vents on the front and side of the appliance are not covered and that sufficient air
circulation is possible. For this reason, do not run the appliance in a closed area, this can lead to overheating
and permanent damage.
•Prevent the fans from being obstructed by cloth, fiber or plastic when in operation. As this will cause the
refrigerator not to work properly.
Installation
•After unpacking the appliance remove the packing materials and place the appliance on a level and sturdy
floor near power socket.
•Check the appliance for any transit damage, any damage must be reported to CoolMed immediately.
•Choose a dry and well-ventilated space for the appliance.
•Do not place the appliance near a heat source or direct sunlight and leave at least 10cm all-round the unit for
adequate ventilation. Failure to do so may affect the performance of the appliance.
• Never place the appliance on a location where water can reach or with high moisture.
•The appliance should never be used outdoors or left in the rain.

4
For Customer Services & Spare Parts please call 0161 772 5666
Opening times: Monday-Friday 9am-4pm
Or visit us at www.coolmed.co.uk
Power supply preparation
Before plugging in the appliance for the first time make sure the power cable is free from damage and check
that your voltage is suitable, the appliance has a multi voltage power supply from12v DC or mains voltage 220 -
240v AC.
There are two sockets on the appliance, one 12v DC and another 220-240v DC, you can use one of the two
sockets.
When charging in a car the DC12V should be used. To avoid a flat car battery do not leave the appliance
plugged into the cigarette lighter socket for extended periods while the engine is switched off. The unit must
be disconnected from the vehicle before high speed battery chargers are used.
Operating
Plug in the appliance, the display will be on and the fan in the appliance will begin to run. Ensure that the
refrigeration is set at the correct temperature before use.
The temperature in the appliance is controlled by the temperature control panel located on the front of the unit.
Press the up or down buttons the current temperature setpoint will blink, select the desired temperature
setpoint by pressing the up or down buttons, the display will then revert to the actual temperature on the
controller display. The system will then work according to new temperature setting, the refrigerator will now run
to achieve the desired set temperature.
If the temperature in the refrigerator is higher than set temperature the refrigerator will begin to reduce the
temperature.
If the temperature in the refrigerator is lower than set temperature the refrigerator will begin to increase the
temperature.
Press the POWER button the appliance will turn off, Press the POWER button again the appliance will turn
back on.
Press the MUTE button to set to mute mode for silent operation, the fan in appliance will run slowly. Note that,
in silent operation the unit may take longer to cool. Press the MUTE button again to set to normal mode.

5
For Customer Services & Spare Parts please call 0161 772 5666
Opening times: Monday-Friday 9am-4pm
Or visit us at www.coolmed.co.uk
Usage
Make sure that the vents on the side of the unit are not covered and that sufficient air circulation is possible. For
this reason, do not use the unit in a closed area, this can lead to overheating and permanent damage.
Please make sure that the lid of the unit is always closed properly. If the door is not closed correctly this causes
higher current consumption and poor cooling performance.
To obtain optimized cooling, pre-chill the refrigerator without contents for 1-2 hours before putting contents into
the refrigerator.
Do not overfill, always allow some airspace around the contents.
Do not leave the lid open longer than is necessary and do not open the lid more than necessary.
Do not place the unit in the sun, this can lead to a substantial reduction in cooling capacity.
If the unit is used for a long period of time, it is advisable to ensure that the inside of the unit is free from ice
because this can affect the cooling performance considerably. Rooms or areas with high humidity are
conducive to the formation of condensed water and ice. The settings are programmed so that icing cannot
occur with usual humidity. If ice forms inside the unit due to the climate, turn off the unit in order to thaw the ice.
After use – please unplug from the electrical supply and allow the unit to return to normal room temperature.
Clean and store the unit in a clean dry place, leave the door slightly open to prevent stale smells and mold
formation.

6
For Customer Services & Spare Parts please call 0161 772 5666
Opening times: Monday-Friday 9am-4pm
Or visit us at www.coolmed.co.uk
Maintenance
It is essential that you unplug the appliance from the mains and transfer the contents where they can
be stored and monitored at the correct temperatures before cleaning.
• Wipe the inner compartment with warm water and neutral detergent. DO NOT allow the control panel, cables
or plug to get wet. NEVER use corrosive detergents, wire brushes, or abrasive scourers to clean the unit.
NEVER use metal or sharp implements to remove debris
• Dry all surface thoroughly.
Technical specification
Model CMPVC12
Rated voltage AC 220-240V～50Hz
DC 12V
Power consumption AC 80W
DC 60W
Capacity 12L
External Dimensions (HxWxD) 290mmx420mmx290mm
Cooling/Warming 5℃to +40℃(based on an ambient temperature of 30℃)
Cooling unit Peltier Thermo Electric

7