Coopers 9222 User manual

Please read carefully before use and retain for future reference.
PARTS
Base x1
Lower handle section x1
Upper handle section x1
Hand grip x1
Microfibre pad x2
Polishing pad x2
Cleaning pad x2
Cloth bonnet x2
ASSEMBLY
•ttach the lower handle
section to the base using
the pre-fitted screw.
•ttach the upper handle
section to the lower handle
section ensuring the locking
pin clicks securely into
position.
•ttach the hand grip to the
upper handle section using
the pre-fitted screw.
•Ensure all fixings are tightened fully before use.
OPERATION
•Choose the desired pads and attach ensuring the plastic clips are secure.
•pply a small amount of a suitable floor/carpet stain remover to stubborn stains to assist
removal.
•Press down on the on right side of the base unit and release the handle by pulling towards
you. This will activate the scrubbing brushes.
•When finished, raise the handle and lock into the upright position.
See table below for recommendations on when to use each set of cleaning pads:
Pa
d
Use
Microfibre pad
For use on hard floors
Polishing pad
For use on wooden floors
Cleaning pad
Use on stubborn stains
Scrubbing brushes (without
pads)
Use on carpets to agitate stains
Cloth bonnet
ttach
over
the polishing pad for use on large stain
s
and high
footfall areas on carpets.
Floor Polisher 9222

CLEANING
•Wipe base clean with a soft dry cloth.
•To clean pads, rinse in cold water.
•To clean scrubbing brushes, brush with a stiff brush.
WARNING
•Never carry the machine by the cord, or pull on the cord to disconnect the machine from a
socket; instead grasp the plug, and pull to disconnect.
•Keep cord away from heated surfaces. Do not pull cord around sharp edges or corners. Do
not close doors on the cord.
•Do not touch moving parts.
•For indoor use only.
•Do not leave appliance unattended, when plugged in.
•Unplug from outlet when not in use, and before removing cleaning or changing cleaning
pads or when the thermal cut out cuts in.
•Do not handle plug or appliance with wet hands.
•Do not allow product to be used by children.
•Keep away from children when in use.
•Check polisher and power cord for damage before use. Do not use if damaged.
•Do not use with or near flammable liquids.
•Do not store appliance near hot ovens or heating appliances.
•Use only manufacture’s recommended attachments.
•Make sure the appliance is connected to the correct voltage.
•No user serviceable parts.
•Do not submerge the appliance in water or other liquid. Do not place or store the appliance
where it can fall or be pulled into a vessel containing liquid.
•Do not use on wet floors or wet stains. llow mopped floors or wet stains to dry before
polishing.
•This machine is equipped with a thermal cut out, to protect the motor from overheating.
The item will cut out if it gets too hot. If the appliance is left plugged in, it could start
unexpectedly when the motor cools.
PACKAGING
•Dispose of packaging at your local recycling centre.
•Dispose of paper and carton separately from plastic bags at your local recycling centre.
•Dispose of item at the end of its lifespan at your local authorised household waste recycling
centre.