Coral Coast CWR036-1 User manual

ITEM NAME : Coral Coast Paradise Cove Retro Metal Rocker
SKU : CWR036-1,CWR036-2,CWR036-3
For assistance with assembly, please contact
Customer Care Center
1-888-880-4884 1/4

(A) Back Qty: 1
PRE-ASSEMBLY PREPARATION:
PANEL AND FITTINGS IDENTIFICATION:
• Please check that all parts and hardware are included before beginning assembly.
• Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts
or hardware.
• Read through the preparation and assembly instructions in full before beginning assembly.
• Please use CAUTION AND CARE WHEN LIFTING the product to avoid personal injury and (or)
damage to the product.
• For ease of assembly, two adults are recommended.
! THIS PACKAGE MAY CONTAIN SMALL ITEMS WHICH SHOULD BE KEPT AWAY FROM CHILDREN
(B) Seat Qty: 1 (C) Left Leg Qty: 1
(D) Right Leg Qty: 1 (E) Connecting Tube Qty: 2 (F) Arm Cover Qty: 2
HARDWARE LIST:
(1) Bolt 8x40mm Qty: 4 (2) Bolt 6x35mm Qty: 2 (3) Bolt 6x40mm Qty: 6
(4) Washer Qty: 10 (5) Nut Qty: 8
2/4
(6) Round t Top Nut Qty: 2
Front Back
FrontBack

Hex Wrench Qty: 1
TOOLS REQUIRED:
3/4
STEP-BY-STEP ASSEMBLY:
STEP 1
STEP 2
Insert the rear connecting tube (E) to each of the leg side frames (C/D) as shown.
Secure tube with bolt (1) . Assemble as shown.
Attach the seat bottom (B) to side frame on both sides with screw (3) on the outside, washer (4)
and nut (5) on the inside. Assemble as shown.
C) D)
Front Front
Back Back
E
E
1 1
B) Seat
3
C) D)
4
5
3
Front
Back Back
Front
Spanner Qty: 1

STEP-BY-STEP ASSEMBLY:
STEP 3
STEP 4
4/4
IMPORTANT:
Exposure to harsh weather conditions may encourage rusting of the steel metal components.
Protection from these conditions is recommended.
BE SURE ALL FASTENERS ARE FULLY TIGHTEN BEFORE SITTING ON ROCKER.
Attach the seat back (A) to side frames, on both sides with bolt (2) on the outside, washer (4) and
nut (5) on the inside. Assemble as shown.
Carefully line up holes in arm cover (F) with holes on chair frames. Using a quick downward push,
snap cover over frame.Attach arm holder (F) to each side frame with the bolt (3).
The washer (4) and round top nut (6) should be used underneath the arm cover.Assemble as shown.
22
A) Back
CD
4
5
C) D)
F) F)
4
6
3
4
6
3