Cosmo 668A/KT(750) User manual

WALL MOUNT RANGE HOOD

INSTALLATION PROCEDURES
SAFETY WARNING
HOOD MAY HAVE VERY SHARP EDGES;PLEASE WEAR
PROTECTIVE GLOVES IF IT IS NECESSARY TO REMOVE ANY
PARTS FOR INSTALLING, CLEANING OR SERVICING.
Step 1:
Please put the cooker hood on the wall
and mark the position where you want to
install. We recommend the height from
the hob to the lower edge of the hood
should be from 650mm to 700mm.
10mm
650-700mm
4
2.How to use the push button control
A B C D E
3. How to use the touch control
A: Press Button A once, turn on the light. Press it again, turn off the light.
B: Press button B, the fan runs at the boost speed.
C: Press button C, the fan runs at the middle speed.
D: Press button D, the fan runs at the low speed.
E: Press button E, the fan turns off.
7
Wood Screw
5x60
Expanding Tube
Hook 232
368.35
A B C D E
A: Press Button A once, turn on thelight.Press it again,turn off the light.
B: Press button B, the fan runs at the boost speed.
C: Press button C, the fan runs at the second speed.
D: Press button D, the fan runs at the low speed.
E: Press button E, the fan turns off.
4.How to use the soft touch control
A: Touch A , the fan runs at the low speed. Press it again, the fan turns off.
B: Touch B, the fan runs at the mid speed. Press it again, the fan turns off.
C: Touch C, the fan runs at the high speed. Press it again, the fan turns off.
A、B、C three bottons interact.
D: When the hood is OFF, press and hold D for 3 seconds,and then press C
(to adjust the minute) and E (to adjust the hour) respectively,G acts like
a clock.On the screen, left side is hour and the right side is minute;When
the hood is operating, touch D to control working time of hood,1minutes
per one touch,the longest stay ON time is 1hour.
E: Press E, turns on the light. Press it again to turn off the light.
F: Delay formation: when the hood is operating press F, the hood will not
be OFF at once, it will remain for one minute before it is OFF.
FEDCBA G
Step 2:
According the space between the hole
A&B,drill 2 holes in level on the wall with
8mm in diameter and 60-70mm in depth.
Press the 2 expanding tube provided into
the holes. Tighten the 2 wood screws of
5x60mm which supplied together with the
hood to the expanding tube.Make sure it is
fixed enough and cannot be move.Hang the
cooker hood on the 2 wood screws,make
sure it is to be level and stable.
Exhaust pipe
Air outlet
Step 3:
Take out the cooker hood from the carton
and put it on a horizontal work table
gently. Fix the exhaust pipe into the air
outlet of the inner duct, and then fix the
exhaust pipe into the top of reducer, make
sure it is connected to the reducer tightly.