Costway NP10363 User manual

Kids Climbing Arch With Ramp
NP10363
NP10543
NP10544

• The product must be installed and used under the supervision of
an adult.
• Read through each step carefully and follow the proper order.
• Remove all packaging, separate and count all parts and hardware.
• Please ensure that all parts are correctly installed, incorrect
installation can lead to a danger.
• We recommend that, where possible, all items are assembled near
the area in which they will be placed in use, to avoid moving the
product unnecessarily once assembled.
• Ensure a secure surface during installation, and place the product
always on a flat, steady and stable surface.
• Please check and maintain it regularly, and the most important
part needs to be suspended, fixed, or anchored to the ground.
BEFORE YOU START
Attention: For home use only.
Attention: The product is not suitable for the children under 3
years.
Danger: Keep all small parts and packaging materials for this
product away from babies and children, otherwise they may pose
a choking hazard.
Danger: Lack of attachment may cause a risk of tipping or falling
hazard.
Please read all instructions carefully
and keep it for future reference.
WARNINGS
GENERAL WARNINGS
01
OLAKIDS

INFLATABLE
BOUNCER
CAUTION:
Not suitable for
children under 3 years.
Small parts may be
swallowed.
WARNING!
ELECTRICALLY OPERATEDPRODUCT
KEEP THE INSTALLATION INSTRUCTION FOR FURTHER REFERENCE
PLEASE READ ALL OF THE SAFETY RULES BEFORE SETTING UP
We BELIEVE IN SAFETY FIRST. PLEASE FOLLOW ALL OF THE RULES
FOR YOUR CHILDREN'S SAFETY
ADULT SUPERVISION REQUIRED. OPERATING BLOWER (AIR PUMP)
NOT
RECOMMENDED FOR CHILDREN UNDER 12 YEARS OF AGE. AS
WITH ALL ELECTRIC PRODUCTS, PRECAUTIONS SHOULD BE
OBSERVED DURING
HANDLING AND USED TO PREVENT ELECTRIC SHOCK.
NOT SUITABLE FOR ADULTS
NOT SUITABL E FOR HIRING OR
COMMERCIAL USE
ADULT SET-UP REQUIRED
ADULT SUPERVISION REQUIRED
WARNING!
ONLY FOR DOMESTIC
USE.OUTDOOR USE
TO BE USED ON SOFT GROUND
ONLY
WARNING!
02
OLAKIDS

SET-UP
● Check the ground where the
product will be set up for any
sharp objects or debris. Do not
install the product over concrete
or any hard surface.
● Place the product on a soft
level surface at least 2 meters
from any structure or obstruction
such as a fence, garage,and
house, overhanging branches,
laundry lines or electrical wires.
● Ensure the play area is free
from hazards such as furniture,
walls sharp objects,other hard
surfaces, etc.
● Set up the product away from
water and any potential fire
hazards.
● Keep the blower (air pump)
and power cord away from areas
of water and moisture.lf water
contacts the blower(air pump),
unplug the blower(air
pump)power cord. Do not
operate until the blower is
completely dry.
● Remove the product from the
carry bag. fany, ensure the slide
cover coming with the product is
stretched well from top to
end.Be sure to place the product
as close to the power source as
possible.
● Stretch the inflation tube and
attach it to the end of the
blower(air pump). Ensure the
iinflation tube is securely
attached and in good condition.
The inflation tube should be
straight and untwisted.
Reposition the blower(air
pump)if necessary.) If the
product comes with water bags,
please follow the
undermentioned instruction.
Otherwise, overleap this point.
Spread out the product, place
and fasten the empty water bags
on the two sides of the product.
Open the stopple and fill water in
the water bags until 80%
fl(about 22kg),push and close
the stopple. Make sure water
bags are firmly attached to the
product and no water leakage
before the product is fully
inflated, and never allow children
to play on the slide without
installing a water bag. (refer to
picture A)
● Push ground stakes through
blower base holes. You may need
to use a hammer for proper
placement. Make sure the
blower(air pump)power switch is
in the OFF position. Ensure the
power connections are safely
sited and tripping hazard is
minimized.
● The blower(air pump)should be
securely sited and affixed to the
ground before use. Plug the
blower(air pump)into an
approved ground outlet.
03
OLAKIDS

● Ensure the blower(air pump)is
free from debris and securely
sited to avoid tipping.
● Turn the blower (air
pump)power switch to ON. The
continual air-flow blower(air
pump)must be left ON at all
times while the product is being
used.(refer to picture B)
● The product should be fully
inflated.
● Ground support stakes are
used for lawn ground surfaces.
Hook and ft each provided
ground stake through each loop
in the bouncer. To prevent
overturn or lift during playing,
push stakes firmly into the soil.
Make sure the hooked end of the
stake is over the loop at all
times during use. The stakes
should be placed level with or
under the ground to reduce
tripping hazards. (refer to
picture C)
● Please check the age
recommendation and user
weights(printed on the product).
You must not exceed the total
weight for the product.
● Put the included play
accessories if any for playing
into the product.(refer to picture
D,E)
● If the product comes with
support cushions at the sides, do
not stand or sit on the cushions.
Hint: Air leak from the seams is
necessary because the product
is inflated by constant airflow
and this leakage is required to
stop the product from becoming
over-inflated.
Hint: It is drawn the user's
attention to the orientation of
inflatable equipment installation
to the sun. The sliding surface of
the product shall not face the
sun as sunshine can glare the
children's eyes when they are
sliding down along the slide.
A B
D E
C
04
OLAKIDS

■ Make sure all children exit the
product.
■ Makes sure the product is free
from foreign objects.
■ If there is water inside the
seams after using the water pool
keep the air blower at work for
about 30 minutes to dry that out
before packing.
■ Turn the blower(air pump)
power switch to OFF.
■ Unplug the blower(air pump)
power cord.
■ Loosen the Velcro and detach
the inflation tube from the
blower. The product should
deflate on its own within 5
minutes.Make sure the product
is entirely deflated. (refer to
picture F) Remove ground
support stakes.
■ Fold the product in half from
both ends, and then fold it in
half 2 more times from both
sides,vertically to the first
fold.(refer to picture G,H,I)
Roll it up tightly from the end
opposite the inflation tube.
(refer to picture J,K)
■ Slip the carry bag over the
folded product and stakes
(plastic balls or water bags ). Zip
the bag.(refer to picture L)
TAKE DOWN
F G H
I J
L
K
05
OLAKIDS

MAINTENANCE
• Checks and maintenance of the
main parts of the toys should be
carried out of regular intervals, if
these checks are not carried out,
the toys could overturn or
otherwise become a hazard.
Whenever practical, the
instructions shall also be affixed
to the toy.
• The seasonal inspection and
maintenance should be
conducted for any damage or
leakage of the product.
• The product can be wiped
clean with a mild detergent.
Keep water away from the
blower(air pump) at all times.
• Do not store the product when
wet. Store the product and the
blower indoors in dry conditions
when not in use.
REPAIR
In case of any breakage of
product，please patch up
through hand sewing. Each type
of product is provided with a
repair kit which includes six
pieces of cloth( two pieces for
each color ). Threads and sewing
needles are not provided and
you should purchase by yourself
(3# sewing needle is
suggested).
• Turn off the air blower and
deflate the product.
• Thread a needle with a spare
thread and tie a knot at its end.
• Close up the broken cloth and
sew along the gap. Tie a knot
after sewing to avoid the loose
thread.
In case of cloth breakage(as
shown in picture M ). please
cover the breakage with a piece
of patching cloth of proper size.
Then sew up the patching cloth
along its sides.
While repairing, you should take
notice that the sewing should
only occur on the surface layer
of the original cloth rather than
reaching its underlayer.
• In case of breakage in the
seam position (as shown in
picture N), the sewing should
only occur between the two split
cloths rather than reaching the
underlayer or any other cloth.
06
OLAKIDS

• In case of large-size breakage
or internal structural damage,
please change the product or
have professionals do the
repairing. Air leakage is normal
in the repaired position and the
air pressure of the repaired
product may be lower than the
original. But it will not affect the
normal use of the product.
• Patching in one position more
than twice is not suggested.
• Needles should be taken good
care of and not be left on the
product after sewing.
• It is suggested that persons
with sewing techniques should
do the repairing work.
WATER PIPE SETUP
INSTRUCTION
NOTE: ONLY FOR THE BOUNCER WITH
WATERSLIDE AND SPRAY FUNC TION.
The different water slide has different quantity of sprinklers, thus,
there are serial numbers on each one to match the product. No.1
will match No.1, and No.2 will match No.2. After confirming the
position of each sprinkler,please wrap the water pipe along with the
velcro.
M N
07
OLAKIDS

● Attach the water tube provided
along the side of the slide using
the hook and loop straps (Fig.
A2 and A3).
● Connect water supply with a
regular garden hose with the
provided water tube. The 2-part
adaptor of the water tube will fit
most garden hoses. Unscrew the
2-part adaptor to find the right
fitting for your hose.
● Attach the sprinkler heads to
the arch above the slide and
water cannon with the hook and
loop attachment (Fig A1) as
shown in the diagram below.
●Turn on the water faucet to the
garden hose. Note: Increase the
water pressure gradually until
water spraying from the
sprinklers reaches the desired
power.
● For wet use, fill the pool with
at least 20cm of water before
playing. Water should be added
regularly to maintain the water
level in the pool.
NOTE: IT IS NORMAL TO HEAR AND FEEL A FAIR AMOUNT OF AIR
ESCAPING FROM THE SEAM LINES. IT
IS NORMAL TO SEE SOME WATER SEEPING OUT AROUND THE
SEAM LINES OF THE POOL.
1
2
Fig.A1 Fig.A2 Fig.A3
08
OLAKIDS

KEЕР INSTRUCTIONS FOR FUTURE USE.
Please give us a chance to make
it right and do better!
Read all instructions before using this bouncer.
Contact our friendly customer service
department for help first.
Replacements for missing or damaged
parts will be shipped ASAP!
Contact Us !
Do NOT return this item.
[email protected]