CPcam CPC106DV User manual

Specifications
Connection diagram
Cautions:
Make sure the power supply is matched with the camera power
input to avoid damage. Neither of the power adapter nor video
cable should not be beyond the longest transportation limit.
Model
Image Sensor
Lowest illumination
Electronic Shutter
Video System
Video Frame Rate
Video Output
Video Switch
Smart IR Control
Day/Night
WDR
OSD Menu
Other Function
Power Supply
Power Consumption
Working Environment
IR LED
IR Distance
Lens
Transmission Distance
1080P 4-IN-1 HD Camera
2.1 Mega pixels CMOS
0.01Lux@（F1.2,AGC ON）, 0 Lux with IR
AUTO, 1/50s~1/60,000s
PAL/NTSC
25/30fps@1920×1080P
1 channel, HDCVI / HDTVI/AHD/CVBS optional
OSD keys or bit switch
Support
Auto(ICR) / Color / B/W / Ext
Support
Support, coaxial cable control via DVR directly (UTC)
AWB, AGC, BLC, DNR, Mirror, MD, Defog
DC12V±10%
< 5W
-30°C~+60°C / Less than 95%RH
Array IR LED, small IR LED optional
10/15/20/30/50/80 meters selectable
Fixed / VF / AF lens optional
Over 300m via 75-3 coaxial cable
Camera
General
1.Image black/white, roll over
1) check the camera rear mode switch cable, adjust it and make sure
the video output is matched for your DVR.
2) go to the camera menu and change the PAL/NTSC mode.
2.Video signal shows horizontal ribbon disturbed area
1) check the power supply cable , it should not be too long, or change
a high quality power adapter to replace.
2) Make sure the DVR BNC port connected stable and the DVR
housing GND grounded.
3.Camera keep white/black , IR led not working or keep on,
glass cover broken, etc.
1) Call the franchiser to repair. Please do not open or try
repairing it without permission.
LEFT
UP
RIGHT
DOWN
SET
CVBS
HDCVI
AHD
HDTVI
SET
UP DOWN LEFT RIGHT SET
Zoom In Zoom Out M-Focus M-Focus OSD menu
Key press:
If you choose single signal output. NO OSD key on cable.
(AF Only)
1080P HD CCTV Camera
AHD CVBS HDCVI HDTVI
Thank you for purchasing our product. If there are any questions,
please read this user manual at first, and do not hesitate to contact us.
Note:
This manual may contain some incorrect places, even though it was
published with our carefully proofreading. The new updates will be
added to the next release without notice. Your valuable advice is really
appreciated.
V5.1
4-IN-1
*Yellow BNC analog output and dip switch are optional
1080P DVR
HD video
12V DC
OSD MENU
power adapter
coaxial cable
CVBS output
yellow
green
21
mode switch
1 2
on
ON
21
ON
21
ON
21
ON
HD TVI HD CVI Analog AHD
*Mode Switch style may change without noce, please refer to the final product

OSD Menu Control
Functions brief OSD Menu Control
*
*
*
*
*
*
*
HD CMOS sensor
Within high sensitivity CMOS image sensor, 1080P video
output , very low illumination Prefect image quality emerge
both on day and night environment
4-IN-1 Multiply Video modes output
Support 4 HD signals switch output, AHD/HDCVI/HDTVI/
CVBS, easy to use switch cable
*AF Zoom ,OSD menu control over coaxial cable (UTC)
Motorized auto focus HD lens, auto trigger focus after zoom
(AF lens only)
OSD menu control up the coaxial cable(UTC)
Camera parameters can be setup via built-in menu. All the
configuration can be changed by back-end DVR directly
up the coax. No need press the cable button
Over 300 meters long distance video signal transportation
Smart IR control, AGC, D-WDR, DNR
Wide range voltage adaptation, Lightning protection
Strong and pretty housing, installations angles can be
adjusted
Please install this device in appropriate temperature,
-30 ℃- 60 ℃or -22℉- 140℉, keep away from
corrosive gas and liquid.
Don’t put the camera direct to the sunlight, it is
recommended installing it under a sun shade.
Caution :
1. Main Menu
5. Day & Night
6. NR
7. Special
8. Adjust
9. AF
10. Exit
2. Exposure
3. Backlight
4. White Balance
1) SHUTTER: electric shutter exposure control
2) AGC: automatic gain control
3) SENS-UP: electronic sensitivity
4) BRIGHTNESS
5) D-WDR: digital wide dynamic range
OFF BLC HSBLC
ATW AWB INDOOR OUTDOOR MANUAL
EXT AUTO COLOR B/W
1) CAM TITLE:
2) D-EFFECT: Mirror, Flip, Rotate
3) MOTION:
4) PRIVACY:
5) LANGUAGE: ENG/CHN1/CHN2/GER/FRA/ITA/SPA/POL/RUS/POR/NED/
TUR/KOR/JPN/HEB/ARB
1) SHARPNESS
2) MONITOR
3) LSC
4) VIDEO OUT
1)AF MODE: SEMI / AUTO / OFF(AUTO: keep tracking focus)
2)ONE SHOT AF: (Press and start a focus)
3)DTN AF: ON / OFF (On: trigger AF when day and night switch)
4)LENS INIT: (Press to calibrate the AF lens if lens can not auto focus)
5)POWER MODE: SAVE POSITION / WIDE / OFF
(AF lens only)
SAVE AND EXIT / EXIT / RESET
36-00-R41107