Crazy Foil JET 2018 User manual

ASSEMBLY GUIDE
JET 2018

SUMMARY
IN PARTS
IN YOUR BOX P.7
THE MAST P.8
THE FOILS P.9
FRONT FOIL & FUSELAGE P.10
MAST & FUSELAGE P.11
REAR FOIL & FUSELAGE P.12
FIN & FUSELAGE P.13
OPTIONS
EASY P.14
LOW WIND P.19
PRE ASSEMBLED
IN YOUR BOX P.1
STANDARD CONFIGURATION P.2

IMPORTANT NOTICE
STRENGTH OF THE SCREWS
ALL SCREWS NEED TO BE TIGHTEN WITH THE ALLEN KEY AT HAND-FORCE FIRST.
WHEN THE MAXIMUM IS REACHED, TAKE A CLAMP AND SCREW BY A QUARTER TO A HALF TURN MORE.

PRE ASSEMBLED

IN YOUR BOX
PRE-ASSEMBLED
Foil 18’’
Foil 23’’
Fuselage
Mast base+screws+nuts
Boots kit
Mast 34’’
USE ONLY FOR EASY CONVERSION
1

1.
STANDARD CONFIGURATION
PRE-ASSEMBLE
REAR FOIL
Foil 18’’
Fuselage
2

STANDARD CONFIGURATION
PRE-ASSEMBLE
Foil 23’’
Fuselage
FRONT FOIL
2. 3

STANDARD CONFIGURATION
PRE-ASSEMBLE
3.
Mast
Fuselage
4

STANDARD CONFIGURATION
PRE-ASSEMBLE
4.
Mast base
Mast
5

STANDARD

IN YOUR BOX
IN PARTS
Foil 18’’
Foil 23’’
Fuselage
FOILS KIT FUSELAGE KIT
Stripes
Fuselage
nose
MAST KIT
Logo plate
Mast 34’’
T-SLOTS (threaded)
M8 50
M8 40
FT-23
FB-23
BB-18
FB-18
FIN
M8 60
BMF
M8 60
M8 40
M8 30
Mast base
M8
nuts Drill
Allen key
6
FT-18
T-SLOT (non threaded)
OR

1.
STANDARD CONFIGURATION
THE MAST
MAST BASE
A
B
IF USING TRACK SYSTEM
C
IF USING SANDWICH SYSTEM
MAST
BMF
MAST
MAST BASE
M8 60 SCREWS
MAST
MAST BASE
MAST
USE BOARD SCREW AND T-NUT FOR ASSEMBLY TO BOARD
C
rear foot
rear foot
center of
the rear foot
B O A R D
M8 NUT M8 NUT
7
M8 30
M8 40
LOGO
PLATE
M8 60

STANDARD CONFIGURATION
FRONT FOIL & FUSELAGE
2.
A B
C
FT-23
FUSELAGE
FOIL 23’’
FB-23
T-SLOT M8 40
D
8
PUSH WITH ALLEN KEY

STANDARD CONFIGURATION
MAST & FUSELAGE
A B
C
3. D
BMF
MAST
FUSELAGE
MAST
FUSELAGE
SLIDE
SLIDE
The arrow beside the letter(s)
must point toward the center
of the mast
9
JET
GLIDER
ACROBATIC JET
USING TRACK SYSTEM
GLIDER
USING TRACK SYSTEM
ACROBATIC
USING TRACK SYSTEM
EASY
EASY
USING TRACK SYSTEM
SCREW WITH ALLEN KEY

STANDARD CONFIGURATION
MAST CONFIGURATION
10
JET
GLIDER
ACROBATIC JET
USING TRACK SYSTEM
GLIDER
USING TRACK SYSTEM
ACROBATIC
USING TRACK SYSTEM
EASY
EASY
USING TRACK SYSTEM
rear foot rear foot
Position of the fuselage is good only if you position the mast on the board at 25 cm with sandwich installation and 15 cm
with track system.
If you cannot respect these measurements for any reason, compensate by sliding the mast into the fuselage of the
corresponding mesurement difference.
Example:
if the mast center on the board is 5 cm closer to the middle of the rear foot, move the mast forward on the fuselage 5 cm
towards the n.
If the mast center on the board is 5 cm further to the middle of the rear foot, move the mast forward on the fuselage 5 cm
towards the nose.

4.
STANDARD CONFIGURATION
REAR FOIL & FUSELAGE
A B
D E
BBF 18 FOIL 18’’
M8 50
T-SLOT
M8 60
11
FUSELAGE
NOse

5.
STANDARD CONFIGURATION
FIN & FUSELAGE
IF USING THE FIN
IF NOT USING THE FIN
A
A
B
STRIPE
STRIPE
FUSELAGE
NOSE
M8 60
DO IT FOR BOTH EXTREMITIES
12
FIN
FUSELAGE

OPTIONS

EASY

15
IN YOUR BOX
OVERVIEW
EASY KIT
FC
M8 40
MINI MAST
WHAT YOU NEED
from STANDARD
to EASY
BBP 23-29
SMALL FOIL
BIG FOIL
BIG FOIL
SMALL FOIL