CrazyFly HEXA 2 User manual

USER MANUAL
© CrazyFly Kiteboarding 2020
CRAZYFLYKITES.COM
kiteboardingforchildren.com crazyflykites.com/register
REGISTER
YOUR GEAR

2. 3.
PACKAGE CONTENTS
1 x Hexa bag
1 x Manual
4 x Quattro Stix Long
4 x Quattro Stix Short
4 x Screw M6 x 20
4 x Hexa washer
1 x Hexa II footstrap Left – L
1 x Hexa II footstrap Right – R
1 x Hexa footpad Left – L
1 x Hexa footpad Right – R

4. 5.
1. Take 1 pc Quattro Stix Short and 1 pc Hexa footpad Right.
Place the Quattro Stix Short in the front position of the Hexa
footpad frame on the left and on the right side.
3. Adjust all Quattro Stix to the desired position. Make sure there
is one empty position between Quatrro Stix Short and Quattro
Stix Long.
4. Place the Hexa footpad Right on the board and select desired
insert position. This determines your stance width.
2. Take 1 pc Quattro Stix Long and continue on the Hexa footpad
Right. Place the Quattro Stix Long in the back position of the Hexa
footpad frame on the left and on the right side.
HOW TO MOUNT

6. 7.
5. Put 2 pcs Hexa washers in place, one to the left and the other
one to the right side of the Hexa footpad. Make sure the holes in
the washer are aligned with the inserts on the board. Tighten 2 pcs
screws slightly - left and right side of the Hexa footpad.
6. Adjust the Hexa footpad angle to the desired position.
7. Fully tighten the screws. Please check the footpad screws after
the first few rides, as they may come loose. If loose, make sure to
fully tighten the screws.

8. 9.
8. Take the Hexa II footstrap and open the velcro. Thread the
velcro through the Quattro Stix. It is best to start on the Quattro
Stix Long in the left side of the Hexa footpad right (inside of the
foot). Then continue with threading the velcro through the Quattro
Stix Short on the same side.
10. Thread the Velcro through the Quattro Stix on the right side
(outside of the foot) on the Hexa footpad. Slide the Quattro Stix
inside the footstrap.
9. Slide the Quattro Stix inside the footstrap. Tighten and close the
threaded velcros. 11. Tighten and close the velcro.

10. 11.
12. Step inside the Hexa II Binding.
13. Adjust the Hexa II footstrap with the velcros for the best fit.
14. If further adjustments for the angle of the binding is needed,
loosen the screws a little until the Hexa II Binding is able to spin.
Adjust the angle again to the desired position and fully tighten the
screws. 16. Enjoy the ride!
15. If further adjustments for the footstrap position and footpad
position are needed, undo the screws completely. Lift up the Hexa II
Binding, push the Quttro Stix down so they pop out of the Fusion
Frame. Adjust the Quattro Stix to the desired position and pop
them back in the Fusion Frame. Mount the Hexa II Binding back
on the board to the desired position and fully tighten your
screws.

USER MANUAL
© CrazyFly Kiteboarding 2020
CRAZYFLYKITES.COM
kiteboardingforchildren.com crazyflykites.com/register
REGISTER
YOUR GEAR