Creative Playthings WILL9WPP12 User manual

WILLIAMSBURG PREMIUM PACK 12
WILL9WPP12-100 Rev C (05-20)
© Copyright 2018, Creative Playthings
CHILDHOOD STARTS HERE
WILL9WPP12
W P P 
Cartons for this Play Set:
1 63006-421 Williamsburg Box 1 (Hardware)
1 63006-422 Williamsburg Box 2
1 63006-423 Williamsburg Box 3
1 63006-445 Williamsburg Roof (Hdwre & Instr)
1 SH946-102 Access Ladder, 5ft
1 63058-202 4 Position Swing Beam
1 63060-222 9ft Swing Beam Legs (Hdwre & Instr)
1 50546-777 3 Swings, 1 Trapeze
1 15166-400 10 ft. Super Wave Slide
1 AG942-400 Access Ladder Handles (Hdwre & Instr)
1 AG943-400 Slide Handle (Hdwre & Instr)
1 SM964-402 Gable Fans (Hdwre & Instr)
2 SM963-402 Dormer (Hdwre & Instr)
1 AH201-102Q Rock Climbing Wall (Hdwre & Instr)
1 SC907-800Q Williamsburg Play Walls (Hdwre & Instr)
1 SC908-800Q Williamsburg Play Floor (Hdwre & Instr)
1 63081-102 Ice Cream Stand (Hdwre & Instr)
1 63008-221 Skybox 1 (Hdwre & Instr)
1 63008-222 Skybox 2
1 SJ926-810 Skybox Wood Roof (Hdwre & Instr)
1 15140-400 14ft Swoosh Slide
1 50398-700 Swoosh Slide Skybox Pk (Hdwre & Instr)
1 SC904-800Q Skybox Play Floor (Hdwre & Instr)
1 AP970-104 Bubble Panel (Hdwre & Instr)
• Start by assembling the Williamsburg tower. Instructions and
hardware are in the cartons noted at left. Notice the gym is ro-
tated 90° from the position shown in the instructions
• Wait to install the Access Ladder, Slide, and Wall Slats until after
the rest of the play set is complete.
• Wmsbg step 2. Do not install the Sandbox End on the end ad-
jacent to the Skybox. It will be replaced when installing the play
oors.
• Wmsbg step 7. Do not install the safety rail. It will be used on the
Play Walls.
• Wmsbg step 14. Do not install the End Wall Support adjacent to
the Skybox. It will not be needed.
• Wmsbg step 15. No Swing Mount is needed.
• Once the roof, roof supports, and ridge cap are installed, pro-
ceed with the Skybox tower.
• Skyboxstep2.Omitthesandboxendunderthegym.Theoor
transition from the Skybox Play Floor will be used instead.
• Skybox step 11. Use the front posts from The Skybox Roof
(SJ926-810) in place of the post extensions.
The components of this gym can be combined with
others to create different play sets. This is the best
orderofassemblytocreatethisspecicset.
Read this sheet and all instructions included with the
different parts before assembly.
See the Instructions and Owner's Manual included in
carton 63006-445 for important safety information.
Dimensions of assembled package:
22' 4" wide x 18' 2" deep x 12' 9" tall
Dormer

© Copyright 2018, Creative Playthings
WILLIAMSBURG PREMIUM PACK 12
WILL9WPP12-100 Rev C (05-20) Page 2
• Skybox Step 17. Wait to install the wall slats on the back
where the bubble panel will mount, and the side where the
Swoosh Slide will mount until after installing the bubble
and slide.
• Skybox Step 21 & 22. Install the slats in reverse orientation
so the opening is on the opposite side. Install the ladder
aligned with the opening.
• Ignore the special instructions regarding mounting with
playoorsintheSkyboxinstructions.Adifferentmethod
will be used.
• Install the 9ft Swing Beam. Instructions are in carton
63060-222.
• Install the Skybox Play Floor (SC904-800Q) and the
Williamsburg Play Floor (SC908-800Q) using the method
found in the Skybox Play Floor instructions on Page 3 titled
"Install the Skybox Play Floor adjacent to a gym with a Play
Floor." Some parts of the Williamsburg Play Floor will be
cuttot.
• Install the Skybox Wood Roof (SJ926-810).
• Install the Gable Fans (SM964-402).
• Install the Bubble Panel (AP970-104) and the wall slats on
either side.
• Install the 14ft Swoosh Slide using the instructions in the
Swoosh Slide pack (50398-700). Install the wall slats on
either side.
• Using a ladder, install the Dormers (SM963-402) in the po-
sitions shown. Ladder access may be obstructed by later
installations.
• Install the Play Walls (SC907-800Q).
• Install the Rock Climbing Wall (AH201-102Q) at the back
of the main tower as shown above.
• Install the Ice Cream Stand (63081-102) at the end of the
Skybox tower as shown above.
• Set the access ladder and slide as shown in the picture on
the preceding page. Check spacing.
• Fasten access brackets to the inside of the ladder rails.
Secure the access ladder using the method shown in step
17 of the Williamsburg instructions.
• Fasten the Access Ladder Handles (AG942-400) to the Ac-
cess Ladder.
• Install the slide mount and slide using the method shown in
steps 23 and 24 of the Williamsburg instructions.
• Install wall slats in the postions shown in images above
and on page 1, using the methods from the Williamsburg
Instructions. Gaps must be narrower than 3-1/2" or wider
than 9" to prevent potential head entrapment.
• Mount one hand grip to the entrance wall slat between the
ladder and the slide on the front of the gym. Mount the
other hand grip to the adjacent post at the same height,
using1/4x1-1/2"lag screwsand1/4"atwashers.Drill
3/16" diameter pilot holes for the lag screws.
• Mount one Slide Handle (AG943-400) above the Super
Wave Slide and one above the Swoosh Slide.
• Double-check all fasteners are secure and all recessed
hardware is covered by hole caps.
Rock Climber
Swing Beam
Swoosh Slide
Gable Fan
Bubble Panel
Ice
Cream
Stand
Play Walls