Cres Cor H137SRR Series Manual

Models: H137SRR SERIES for use with Convotherm C2020 Roll-In Rack (not included).
Cabinet model number:
Cabinet serial number:
Authorized Service Agency:
Ph: Fax:
Keep this manual for future reference.
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
FL-2335
Rev. 0 (2/07)

SUBJECT PAGE
INSTALLATION INSTRUCTIONS ............................................................................................1
Illustration (Leg Adjustment), Figure 1..............................................................................1
OPERATING INSTRUCTIONS ..................................................................................................2
Illustration (Control Panel), Figure 2 .................................................................................2
MAINTENANCE INSTRUCTIONS
How to Clean the Unit........................................................................................................3
Replacement Parts (Cabinet) ..............................................................................................4
Illustration (Cabinet Parts)..................................................................................................5
Replacement Parts (Power Unit) ........................................................................................6
Trouble Shooting Guide .....................................................................................................7
Wiring Diagram..................................................................................................................8
How to Reverse the Door Opening.....................................................................................9
NOTES.........................................................................................................................................10
SERVICE POLICY and AGENCY LIST .........................................................................FL-1400
TABLE OF CONTENTS
FL-2335
Rev. 0 (2/07)
5925 Heisley Road • Mentor, OH 44060-1833

Companion
Holding Cabinet FL-2335
Rev. 0 (2/07) Page 1 of 10
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
IDENTIFYING YOUR CABINET:
Look for this label on the back of your cabinet. This information is needed when calling for questions or service.
ELECTRICAL SPECIFICATIONS:
Model No. Volts Watts Amps Hertz Phase NEMA
H137SRRC2020C 120 1920 16.0 60 1 5-20P
H137SRRC2020C208 208 2000 10.0 60 1 6-15P
H137SRRC2020C240 240 2000 8.6 60 1 6-15P
Note: The above model numbers are basic models. They may be followed by letters: L, M, 2M, D, or ending with S.
HOW TO INSTALL UNIT:
Remove all paper and packing material from inside
of cabinet.
Remove protective paper and vinyl material from
outside surfaces of cabinet.
Place the cabinet in a well-ventilated area.
Place cabinet on level floor. (For cabinets with legs,
adjust the legs of the cabinet to ensure proper fit of
rack into cabinet. See Fig. 1)
Plug cord end into proper wall outlet.
1.
2.
3.
4.
5.
FIGURE 1
Leg Adjustment

Companion
Holding Cabinet FL-2335
Rev. 0 (2/07) Page 2 of 10 5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
Air is VERY HOT when door is opened.
INITIAL OPERATION:
(For first-time operation only)
A new oven needs to “burn off” manufacturing oils
and excess adhesive before its first use.
Do NOT load food into oven until this has
been done!
Turn the POWER switch on. The yellow light will
turn on.
Turn the thermostat to #10.
Let the unit operate for one hour.
Turn unit off and let cool
Wipe inside clean with detergent and hot water.
1.
2.
3.
4.
5.
Figure 2
Yellow Light “On-Off” Switch “Air” Thermostat Thermometer
HOW TO START UNIT:
Turn the POWER switch on. The yellow light will turn on.
Turn the thermostat to #6-1/2.
Preheat cabinet for one (1) hour.
Put food into cabinet
Turn thermostat to desired setting and close door.
No. 8 setting = approx. 185°F / 85°C
No. 6 setting = approx. 160°F / 71°C
No. 4 setting = approx. 130°F / 54°C
Proper food holding temperature is 140°F / 60°C or higher.
1.
2.
3.
4.
5.
NOTE: The optional digital thermometer display flashes
when temperature in center of cabinet is below
140°F (60°C) or above 250°F (121°C). Call the
factory if you need different settings.
TO TURN OFF UNIT:
Turn the POWER switch off. The yellow light will go out.

Companion
Holding Cabinet FL-2335
Rev. 0 (2/07) Page 3 of 10
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
BEFORE cleaning the cabinet: Unplug cord
from wall.
Do NOT hose cabinet with water.
Do NOT get water on controls.
Do NOT use abrasives or harsh chemicals.
Cleaning hints:
Wipe up spills as soon as possible.
Clean cabinet regularly to avoid heavy dirt build-up.
Make a test spot with cleaner.
Follow manufacturer’s directions on cleaner.
Do not mix cleaners.
Avoid drips and splashes
1.
2.
3.
4.
5.
6.
HOW TO CLEAN THE UNIT:
Soil Cleaner Method
CABINET
Inside and
Outside
(Stainless Steel)
ROUTINE CLEANING Soap, Ammonia, or mild
*detergent and water.
1. Sponge on with cloth.
2. Rinse with water.
3. Wipe dry.
STUBBORN SPOTS AND
STAINS Mild abrasive made for stainless steel. 1. Apply with damp sponge or cloth. 2. Rub lightly.
BURNT-ON FOODS OR
GREASE Chemical oven cleaner for stainless steel. Follow oven cleaner manufacturer’s directions.
HARD WATER SPOTS
and SCALE Vinegar 1. Swab or wipe with cloth. 2. Rinse and dry.
*Mild detergents include soaps and non-abrasive cleaners.

Companion
Holding Cabinet FL-2335
Rev. 0 (2/07) Page 4 of 10 5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
CABINET REPLACEMENT PARTS:
ITEM DESCRIPTION 120V 208V 240V
1 Heater Kit, Air 0811-074 0811-074-02 0811-074-01
2 High Limit 0848-060 0848-060 0848-060
3 Power Cord 0810-065-10 0810-039-02 0810-039-02
4 Power Unit (See Page 7) 0675-067 0675-068 0675-068
5 Door - full, solid 1221-557-K
-full, w/window 1221-558-K
-half, solid, top LH, bottom, RH 1221-560-K
-half, solid, bottom LH, top, RH 1221-559-K
-half, window, top LH, bottom, RH 1221-561-K
-half, window, bottom LH, top, RH 1221-562-K
6 Gasket Kit, Body 0861-175
7 Gasket Kit, Door 0861-265
8 Hinge Kit 0519-074-K
9 Latch Kit 1006-122-01-K
10 Tunnel 0546-141
11 Leg, Adjustable 1206-070
Handle, Pull (Black) 0911-102

Companion
Holding Cabinet FL-2335
Rev. 0 (2/07) Page 5 of 10
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
CABINET REPLACEMENT PARTS:
1
23
4
5
6
7
8
9
10
11

Companion
Holding Cabinet FL-2335
Rev. 0 (2/07) Page 6 of 10 5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
REPLACEMENT PARTS:
ITEM DESCRIPTION 120V 208V 240V
Power Unit 0675-067 0675-068 0675-068
12 Power Light 0766-094 0766-095 0766-095
13 Power Switch 0808-116 0808-116 0808-116
14 Thermostat 0848-062-K 0848-062-K 0848-062-K
15 Knob 0595-061 0595-061 0595-061
16 Terminal Block 0852-093 0852-093 0852-093
17 Blower Kit 0769-180-01-SSK 0769-182-01-SSK 0769-182-01-SSK
18 Vent Fan 0769-165 0769-174 0769-174
19 Thermometer (Analog)
Thermometer (Digital) 5238-030-K 5238-034-K 5238-030-K 5238-034-K 5238-030-K 5238-034-K
20 Transformer (used with digital
thermometer) 0769-159 0769-159 0769-159
REPLACEMENT PARTS FOR THE POWER UNIT:
12
13
14
15
20
19
18
17
16

Companion
Holding Cabinet FL-2335
Rev. 0 (2/07) Page 7 of 10
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
TROUBLE-SHOOTING CHART:
FAILURE POSSIBLE CAUSE
1. Yellow light at switch
does NOT light.
1a. Switch is “OFF”.
1b. Cord unplugged from wall outlet.
1c. Circuit breaker/fuse to wall outlet blown.
2. Unit does not heat. 2a. Thermostat set too low.
2b. Switch is “OFF”.
3. Unit gets too hot or
won’t shut off. 4a. Defective electrical parts. UNPLUG UNIT FROM WALL OUTLET.
4. Blower does not work
or makes noise. 5a. Defective blower.
5. GFCI device trips.
6a. The insulation inside the heating elements may have absorbed some
moisture. This may have occurred if the cabinet has not been used for a
long period of time or during shipping and storage of the cabinet. Drain
the water pan if needed. Plug the cabinet into a non-GFCI outlet and set
the thermostat to No. 10. Let the cabinet run for about 1 hour to dry out
the heating elements from any moisture may have been absorbed. If the
circuit breaker trips, turn off cabinet, remove cord from power source,
and call the Factory Authorized Service Agent. After drying the heating
elements, plug cabinet into the GFCI receptacle; the cabinet should run
properly. If the GFCI trips, call the factory Authorized service agent.
GFCI (ground-fault circuit interrupter): A GFCI receptacle is a device that de-energizes a circuit when it
detects an unsafe flow of current to ground. The intention of a GFCI device is to minimize the potential for an
electrical shock
If cause is none of the above, refer to our list of Authorized Service Agencies.

Companion
Holding Cabinet FL-2335
Rev. 0 (2/07) Page 8 of 10
5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
WIRING DIAGRAM
t° t°
POWER
SWITCH
6-15P PLUG
240V, 15A
208V, 15A
G
WB
G
W
5-20P
120V; 20A
8
TRANSFORMER
110V/220V
OPTIONAL
4 3 2 1
5
SENSOR
FOR 208V/240V
TRANSFORMER
110V/220V
4 3
5
SENSOR
TERMINAL BLOCK
1
2
2
1
4
3
BM
A
FAN BM
HIGH LIMITTHERMOSTAT
2 1
8
4
HIGH LIMIT
5 7
HEATER AIR
6 3

Companion
Holding Cabinet FL-2335
Rev. 0 (2/07) Page 9 of 10 5925 Heisley Road • Mentor, OH 44060-1833
OPERATING and MAINTENANCE INSTRUCTIONS
Models: H137SRRC2020C Companion Holding Cabinet
The doors are shipped with the hinges on the right side of the cabinet as standard. The doors on the cabinet
are large and may require additional help when changing the hinge direction.Allow the cabinet to cool if the
cabinet has been in use.
Remove handle bracket and strike plates from cabinet and set aside.
Remove hinge covers and set aside.
Remove hex screws from door gasket bracket assembly and door cover and set aside.
Remove door(s) from cabinet, rotate door(s) 180° and install onto other side of cabinet. For
dutch doors, install the bottom door onto the top position and install the top door onto the bottom
position on the other side of the cabinet.
Remove screws on bottom of (lower) door and install onto top of (upper) door.
Install door gasket assembly and door cover onto bottom of (lower) door.
For single door, remove latch and rotate 180° and install onto holes on upper half of door. For
dutch doors, it is not necessary to change latches.
Install handle bracket and strike plates onto other side of cabinet.
Adjust hinges, latch(es) and door gasket bracket assembly for proper door seal.
Install hinge covers.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
HOW TO REVERSE THE DOOR OPENING (Left hinged door shown):

Companion
Holding Cabinet FL-2335
Rev. 0 (2/07) Page 10 of 10 5925 Heisley Road • Mentor, OH 44060-1833
NOTES: