Crosley CFWMH45125AW Manual

MODEL NUMBERS
USER MANUAL &
INSTALLATION
INSTRUCTIONS
en
Warning:
Before using this product,
please read this manual carefully
dealer or manufacturer for
details.
Power supply: 120V~
Circuit: 15-amp branch
Capacity: 4.5 cu.ft.
CFWMH45125AW
CFWMH45125AX

WASHER SAFETY ..............................................................................3
When Not in Use .......................................................................................5
OPERATION REQUIREMENTS ..........................................................6
INSTALLATION INSTRUCTIONS ......................................................8
Parts Supplied.............................................................................................9
Rough-In Dimensions ..............................................................................9
11
WASHER USE ....................................................................................13
WASHER CARE ................................................................................24
28
BEFORE YOU CALL FOR SERVICE... ............................................29
36

3
Washer
Safety
Installation
Instructions Washer Use
YOUR SAFETY AND THE SAFETY OF OTHERS ARE VERY
IMPORTANT
CAUTION
WARNINGWARNING
WARNING
This symbol indicates the possibility of injury or damage
property.
This
injury.

4
Washer
Safety
Installation
Instructions Washer Use
WARNING
•
•
•
•
• supervision of children is necessary when this appliance is used near
DO NOT reach into the appliance if the drum or other components
•
•
DO NOT tamper with controls, repair or replace any part of this
•
in the user maintenance instructions or in published user repair
• possibility of slipping.
• partially disassembled, or has missing or broken parts including a
damaged cord or plug.
• Pressing the Power button DOES NOT disconnect power.
•
by persons (including children) with reduced physical, sensory or

5
Washer
Safety
Installation
Instructions Washer Use
If the supply cord is damaged, it must be replaced by the
•
The new hose-sets bought from the retailer where the product was
•
reused.
•
PROPER INSTALLATION
•
•
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
•
•
Do not use an adapter.
•
•
• shock.
WHEN NOT IN USE
SAVE THESE INSTUCTIONS

6
Washer
Safety
Installation
Instructions Washer Use
OPERATION REQUIREMENTS
LOCATION OF YOUR WASHER
1.
℃
2. In an area where it will come in contact with curtains or drapes.
3. On carpet. The floor MUST be a hard surface with a maximum slope
of
1/2
NOTE: If floor is in poor condition, use 3/4
IMPORTANT: MINIMUM INSTALLATION CLEARANCES
Back = 3" (7.6 cm)
ELECTRICAL REQUIREMENTS
WARNING
DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG
•
accordance with local codes and ordinances.
CIRCUIT - Individual, properly polarized and grounded 16-amp branch
circuit fused with 16-amp time -delay fuse or circuit breaker.
power supply cord is accessible when the washer is in an installed
position.
POWER SUPPLY - 2-wire with ground, 120V~, single-phase, 60Hz,

7
Washer
Safety
Installation
Instructions Washer Use
GROUNDING REQUIREMENTS
Improper connection of the equipment grounding conductor can result
doubt as to whether the appliance is properly grounded.
1. breakdown, grounding will reduce the risk of electrical shock by
2. equipment-grounding conductor and a grounding plug, the plug
is properly installed and grounded in accordance with all local codes.
licensed electrician replace it with a properly grounded grounding-type
WATER SUPPLY REQUIREMENTS
DRAIN REQUIREMENTS
1.
2. A standpipe diameter of 11/4 " (3.18 cm) minimum.
3.
BACK
47.24''
(120 cm)
Max.
24''
(61 cm)
Min.
3/4" (1.9 cm) garden hose-type so

8
Washer
Safety
Installation
Instructions Washer Use
BEFORE YOU BEGIN
FOR YOUR SAFETY:
WARNING
• This appliance must be properly grounded and installed as described
• N OTE: This appliance must be properly grounded, and electrical
service to the washer.
TOOLS REQUIRED
• A djustable wrench or 1/2
• Adjustable wrench or 9/16 " open-end wrench
• Channel-lock adjustable pliers
Certain internal parts are intentionally not grounded and may
•
present a risk of electric shock only during servicing. Service
IMPORTANT -
•
IMPORTANT -
• ordinances.
• Note to Installer -
Consumer.
• Note to Consumer -
• and electrical skills.
•
•
•

9
Washer
Safety
Installation
Instructions Washer Use
PARTS REQUIRED (OBTAIN LOCALLY)
PARTS SUPPLIED
Cable Tie Drain Hose Guide
ROUGH-IN DIMENSIONS
27.0''
(68.6 cm)
39.8''
(101.09 cm)
SIDE
34.2''
(86.9cm)
39.8''
(101.09 cm)
∗NOTE:
Stacked, 84"

10
Washer
Safety
Installation
Instructions Washer Use
UNPACKING THE WASHER
WARNING:
•
1.
2. lay the washer on its front of back.
3.
4. carton.
5.
6.
4 bolts
4 plastic spacers (including rubber grommets)
4 power cord retainers
warranty.

11
Washer
Safety
Installation
Instructions Washer Use
hardware in the plastic bag provided.
INSTALLING THE WASHER
1.
2.
3. Install the screen washers by inserting them into the free ends of the
inlet hoses with protruded side facing the faucet.
4.
tightly by hand, then tighten another 2/3
5.
into position ensuring inlet hoses do not become kinked. It is important
washer into its final position.
NOTE: To reduce vibration, ensure that all four rubber leveling legs are
firmly touching the floor. Push and pull on the back right and then back
left of your washer.
washer into the hose fitting if it has fallen out during shipment.
Carefully connect the inlet hose marked HOT to the rear “H” inlet

12
Washer
Safety
Installation
Instructions Washer Use
NOTE: Do not use the dispenser drawer or door to lift the washer.
6.
(if the washer is installed under a counter, the washer should not be
washer nuts on each leg up towards the
base of the washer and snug with a wrench.
7.
the hose in a laundry tub or standpipe and secure it with the cable tie
Cable
Tie Cable
Tie
Cable
NOTE: Placing the drain hose too far down the drain pipe can cause a
fit can also cause a siphoning action.
8. Plug the power cord into a grounded outlet.
9.
10.
11. Before starting the washer, check to make sure:
Main power is turned on.
•
The washer is plugged in.
•

13
Washer
Safety
Installation
Instructions Washer Use
12.
13.
14.
CONTROL PANEL
•
•
•
•
-

14
Washer
Safety
Installation
Instructions Washer Use
QUICK START
Press the Power button.
If the screen is dark, a press of the Power
Power
Press to put
NOTE: Pressing Power does not disconnect the appliance from the

W ash Cycles
Normal/
Colors*
For heavily to lightly soiled colorfast cottons, household
linens, work and play clothes.
Sheets* and similar bulky items.
Heavy
Duty* or towels.
clothes
Towels* For items such as towels, sheets, pillowcases and dish
rags.
Sanitize*
options.
Baby Care
the baby skin.
laundry may become damaged See the Care and Cleaning
section.
Rinse &
Spin
15
Washer
Safety
Installation
Instructions Washer Use

SOIL LEVEL increase or decrease the
can choose between
Extra Light, Light,
Medium, Heavy or Extra
WASH TEMP
Adjust to select the proper
always cold to help reduce
energy usage and reduce
setting of stains and
wrinkles.
Follow the fabric
manufacturer’s care label
when selecting the wash
To change the wash
wash Temp button until
desired setting.
Extra Hot.
By design, to protect
fabrics, not all wash
SPIN SPEED
Changing the Spin speed
changes the final spin
manufacturer’s care label
when changing the Spin
speed.
To change the Spin
speed, press the Spin
Medium, High or Extra
High. Higher spin speeds
Higher spin speeds
the clothes and will help
also increase the possibility
of setting wrinkles on some
fabrics.
16
Washer
Safety
Installation
Instructions Washer Use

STEAM
Steam adds steam into
the washer to assist with
loosening stains on the
To use:
1.
2. Select the Add Steam
steam.
3. Press the button.
WATER
PLUS
of the main wash.
To use:
1.
2. Select the Add Water
3.
SPEED
WASH
This option reduces the
by optimizing the wash,
rinse and spin actions and/
or gently raising the wash
cleaned faster. Option
Towels,Baby Care or
and options selected.
To use:
1.
an option.
2. Make any adjustments
to Soil, Temp and Spin
as desired.
3. button to reduce the
4.
EXTRA
RINSE
detergent from soiled
loads.
17
Washer
Safety
Installation
Instructions Washer Use
Press the button.
Press the button.
.
SIGNAL Use the Signal pad to
turn the Signal on or off
all knob turns and button
presses.
means it is an acceptable
option,and a double beeps
means not an acceptable
option.

PRE SOAK garments prior to the
begins with a brief tumble
and then proceeds to
soak the clothes with
an additional 10-20 minutes
from the main wash
compartment in the
EXTRA
RINSE and
PRE SOAK
can lock or unlock the
Children cannot
accidentally start the
washer by touching
buttons with this option
selected.
To lock the washer, press
and hold the Extra Rinse
3 seconds.
To unlock the washer
controls, press and hold
NOTE: The Power button
can still be used when the
machine is locked.
MY CYCLE
set the desired setting
spin speed and wash temp
settings and hold down
3 seconds, A beep will
set the desired setting and
has been started.
prior to pressing
18
Washer
Safety
Installation
Instructions Washer Use
button.

DELAY
Wash button to choose
want to delay the start of
desired time is reached,
press the button. The
machine will count down
when the delay is counting
down, the machine will
and press
again in order to restart
the countdown.
Display time remaining until the
the balance of the load
see the time remaining
on the display increase to
spin speed to handle
unbalanced loads.
BA
CD
selected.
Press to start a wash
running,pressing it once
will pause the washer.
Press again to restart the
garment,please press the
The washer will unlock the
door. Press again to restart
washer will drain first,then
unlock the door when it is
paused.
NOTE: The washer
checks after pressing the
flows,this is normal.
Wash Time Delay Time
End
Error
ADisplay
BRemain-Delay
CChild Lock
DDoor Lock
19
Washer
Safety
Installation
Instructions Washer Use
button
button.
button.
Pre
-
the door, a double beep will
sound when pressing
pause/add garment button.

FEATURES
THE DISPENSER DRAWER
Slowly open the dispenser drawer by pulling it out until it stops.
After adding laundry products, slowly close the dispenser drawer. Closing
the drawer too quickly could result in early dispensing of the bleach,
fabric softener or detergent.
is a result of the flushing/siphoning action and is part of the normal
20
Washer
Safety
Installation
Instructions Washer Use
NOTE: Liquid detergent will drain into the washer drum as it is added.
•
residue being left on the clothes.