Crossover Symmetry Wall Mounts User manual

INSTALL GUIDE FOR WOOD STUDS
WARNING: THE USE OF THE REQUIRED TOOLS MAY PRESENT AN INHERENT DANGER TO THE PARTICIPANT. READ ALL INSTRUCTIONS BEFORE
BEGINNING. IF YOU DO NOT FEEL COMPETENT TO ASSEMBLE OR MOUNT THE INCLUDED EQUIPMENT, SEEK ASSISTANCE. DO NOT RUSH. FOLLOW
INSTRUCTIONS AS OUTLINED IN THIS GUIDE. ALWAYS CHECK YOUR EQUIPMENT THOROUGHLY AND INSPECT FOR DEFECTS. IF ANY DEFECTS ARE
FOUND, DISCONTINUE USE OF THE PRODUCT. ALL CROSSOVER SYMMETRY EQUIPMENT IS INTENDED TO BE USED ONLY IN THE MANNER SHOWN
IN THE INCLUDED INSTRUCTIONAL MATERIALS. CONTACT US AT WWW.CROSSOVERSYMMETRY.COM WITH ANY QUESTIONS REGARDING THE
ENCLOSED EQUIPMENT OR ITS INTENDED USES.
TOOLS NEEDED:
In order to install CS Wall Mounts™ on a wooden surface, you will need a tape measure, a pencil, a level, and
a power drill with a 9/16"socket and a 1/4"drill bit (in order to make lead holes).
CONCRETE AND METAL INSTALL INSTRUCTIONS:
DO NOT ATTEMPT TO INSTALL ON METAL OR CONCRETE SURFACES WITH THE INCLUDED
HARDWARE SET, you will need to purchase additional hardware. For specifications and alternate install
instructions, please visit GoCrossover.com or write [email protected]
INCLUDED HARDWARE: (1 SET)
8
AB2
( Qty.4 )Heavy Duty Permanent Attachment Anchors
OFFICIAL PRODUCT OF CROSSOVER SYMMETRY
INSTALL HARDWARE
WOOD STUDS
Crossover Symmmetry’s Wall Mounts™ provide a high traffic, commercial grade workout station that can safely
anchor heavy resistance training accessories and Crossover Cords™ to add functionality to performance facilities.
READ ALL INSTRUCTIONS BEFORE BEGINNING

Copyright © 2013 Crossover Symmetry. 5450 Wadsworth Bypass, Unit B, Arvada, CO, 80002. GoCrossover.com
For additional questions, please contact us at [email protected].
Before installation, make sure that
there is enough room to perform the
crossover exercises. You will need an
area 7'wide and 9'deep, centered
over the intended install location.
WALL
1
Multiple Station Installation:
The ideal spacing between the
exercise stations is 24"from the
outer wall mounts.
48"
24" 24"
2
A
7'
INTENDED
INSTALL
LOCATION
9'
64"
14"
CHART
EXERCISE
B
18" 18" Wall Mount Install:
1. Using a stud finder, locate the
vertical stud that are exactly 48"
apart. These are the stud that you
will be installing the wall mounts
into.
2. Measure 64"from the floor on the
center of both studs. Mark with
pencil.
3. Place the bottom of the wall mount
at the 64"mark and with a pencil
mark both holes in the wall mount
to identify where to drill.
4. Repeat step 2-3 for the lower wall
mounts at the 14"mark as seen in
the picture.
5. Drill a 1/4"lead hole for each
screw at the mark that you just
made. Place a wall mount over the
lead holes, and install the wood
screws using the 9/16 socket (A).
Chart Install:
The chart can be installed in the
middle of the station as seen in
the picture or inbetween stations.
If installing into a fitness facility,
where exercises like handstand
pushups will be performed, it is
recommended that the chart is
hung between exercise stations.
(for example: in the image below,
the chart should be hung just
below where it says 24")
BE SURE TO TEST THE INSTALLATION OF
EACH WALL MOUNT BY PULLING ON THE
CENTER RING WITH SUBSTANTIAL FORCE.
EXERCISE
CHART
EXERCISE
CHART
EXERCISE
CHART