Crux Sightline RVCTY-71c User manual

RVCTY-71c
TOYOTA:
2012 -2013 Tacoma
R
ev.
061113
REAR-VIEW INTEGRATION
w/CAMERA
FOR TOYOTA TACOMA 2012-2013
We recommend reading this installation guide first before starti
ng
any CAMERACONNECTIONS OVERVIEW
wort<.
Following these instructionsfrom
"S
tart"
to"
Finish" will ensure
a smooth and hassle free installation.
We
offertelephone support M-F
9:00AM
-5:00PM
PDT at 1 [phone]. We are here
to
help.
PARTS INCLUDED:
(1)
Rear Camera(TY-71c)
(1)
TY-71c Harness
(1)
TY-71c Cemera Harness
(1)
Instruction
Camera Specifications:
-Lens Angle 170 Degrees
-Resolution 420 TV Lines
-Min. Illumination 0.2Lux
-Voltage 12v
-Operating
Temp.
-22·F-
176.F
-NTSC .
-Reference Lines
-Shutter
Speed
1/60s-
20us
-Waterproof
-Pixels 656 x 492
PRECAUTIONS:
-Removethe negative side
of
the battery
to
avoid
any
short circuits
durring the installation.
-Do
no
t
ins
tall
the interface near any major components
or
near the
HVAC system. This may cause damage
or
overheating
to
the vehicle.
-Do
not
disconnect
the
airbag connection behind
the
radio panel.
PRELIMINARY:
Please read the entire manual before installing this interface.
TOOLS NEEDED:
-Drill
Gun
-Panel Remover
INSTALLING THE CAMERA AND CABLE
1
. Remove thetailgate
cover.
2. On therightside
of
the tailgate handl
e,
drill a
5/8"
hole.
3. Rou
te
the camera powerand video connections through
5/8"
hole,
an
d secure
the
camera to the handle and make power connection.
4.
Connectthe 4-Pin pluQ
to
the pr
ov
i
ded
factory plug
in
side the
tailgate, as the wires are pre-ran for the
camera
5. Re-install the tailgate cover.
-NEXT-
6. Remove the factory radio and connectthe
16-Pin
and
28
-Pin
T-Harness.
7. Route t
he
5
!oct
cable
and
harnesstowards the fuse panel.
8.
Connect
th
e
4-Pin
and
14-Pin
T-Harness above the factoryfuse
panel.
9. Test all connections before re-installingthe radio into the dash.
DJ
=sTI
16-PIN
(m
ale plug)
[]]
=sTI
28-PIN
(female plug)
...r1llll
ATFACTORY
'IIIII
HARNESS
~~~=sTI
4-PIN
L_l___j
(m
ale plug)
rn
14-PIN
=sTI
(fem
ale plug)
...r1llll
AT
FUSE
'IIIII
PANEL
PARKING LINE
16-PIN
=sTI
~
(m
ale plug)
~
28-PIN
=sTI
~
(female plug)
B
4-PIN
=sTI
~
(male plug)
~
14-PIN
~
(male plug)
=sTI
~
The parking linesare there
to
assistyou
wh
ile reversi
ng
.
What
the
lines mean:
Yellow Line: CLEAR
Purple
Li
n
e:
GETTING CLOSE
Red Line: WARNI
NG-
VERY CLOSE
To
remove the pa
rki
ng
lines simply cut the
GREEN
wi
re
located near
the
4 pin tail connec
tor
in the tru
ck.
YELLOW
PURPLE
RED
4-PIN
=sTI
I
(male plu
g)
I
15ft
(extension) I POWER
+
CONNECTION
WHITE
:;::==I
(Reverse Image)
II===
GREEN
CONNECT
TO REVERSE (Parking Grid)
CONNECT
TO ACTIVATE
REVERSE IMAGE
If
the camera angle is inverted (
up
s
ide
down), please
cut
the WHITE
wire located near the pin
ta
il
connector in the t
runk
.

RVCTV-71c
TOYOTA:
2012
-2
013 Tacoma
Rev
. 061113
REAR-VIEW INTEGRATION
w/CAMERA
FOR TOYOTA TACOMA 2012-2013
INSTALLING THE CAMERA AND CABLE
1. Remove the tailgate cover.
2.
On
the right side
of
the tailgate handle, drill a 5/8" hole.
3.
Route the camera power and video connections through 5/8" hole, and secure the camera
to
the handle and make power connection.
4.
Connect the 4-Pin plug
to
the provided factory plug inside the tailgate, as the wires are pre-ran for the camera.
5.
Re-install the tailgate cover.
-NEXT-
6.
Remove the factory radio and connect the
16-Pin
and
28-Pin
T-Harness.
7.
Route the 5 foot cable and harness towards the fuse panel.
8.
Connect the
4-Pin
and
14-Pin
T-Harness above the factory fuse panel.
9.
Test all connections before re-installing the radio into the dash.

I11 IIII IIIII IIIII IIIII II \Ill \IIIII II IIIII\ IIIII IIIII\ Ill \Ill
249RCTY71C
ux l : : ~vcTY-71C Rear-View Cam. 12-13 Toyota Tacoma
-