CSL DualCom UDL User manual














Installation of DualCom UDL to
Texecom Premier and Elite
CSL262V8 14042016
DualCom Setup
Place the Texecom panel in engineer mode
Connect the aerial provided to the DualCom
Connect the DualCom directly to the COM 2400 board via the “to panel digi” port on
the DualCom
The DualCom will go through its power up/registration process which will take
approximately 2-3 minutes
The top “SVC” LED will start to pulse like a heartbeat once locked onto the network
The signal strength will then be displayed
Leave the DualCom to conduct an internal network survey – this will happen
automatically. The display will show 0.0, 0.1, 0.2, etc
Once the survey is complete you then need to proceed to panel programming
If triggered inputs on the DualCom are being utilised in fast format then proceed to
“Panel Programming (UDL)”
Panel Programming (SIA)
Enter engineering menu
Press down arrow until you reach “UDL/Digi Options”, then press YES
Press down arrow until you reach “Program Digi”, then press YES
Display shows “ARC 1 Protocol Disabled”. Press NO and then down arrow until “SIA
Level II” is displayed
Press YES, then YES again, display shows “Primary No”. Press NO and enter number 01
followed by YES
Press down arrow once to “Secondary No”, then press NO and enter number 01
followed by YES
Press YES until “Account Number” is displayed, press NO then enter the DualCom’s chip
number followed by YES
Press down arrow to “Config (* * * * * * * *)” press NO then down arrow until Send SIA
Text is displayed, press No and display will now show “Send SIA Text (* * * * * * * T)”
press YES
Press menu then down arrow until “Digi Options” is displayed, press YES
“Digi Options (* * * * * *)” is displayed, press NO twice
Display will now show “Digi is Enabled (E * * * * *)” press YES
Unit is now setup to send SIA to the ARC via the dial capture ports




Panel Programming (UDL)
(Note if you have completed SIA programming then skip to point 5)
From engineering menu press down arrow until you reach “UDL/Digi Options”, press
YES
Press down arrow until “Digi Options” is displayed, press YES
“Digi Options (* * * * * *)” is displayed, press NO twice
Display will now show “Digi is Enabled (E * * * * *)” press YES then menu
Press down arrow until you reach “UDL Options” press YES
Press down arrow until you reach “UDL Password” factory default is 1234, this is
optional if you wish to change then press NO and enter your password followed by
YES
Press down arrow until “UDL Options (* * * * * *)” is displayed, press NO
Press down arrow until “Manual Call-Back” is displayed then press NO again
Display will now show “Manual Call-Back (* M * * * *) press YES
Press down arrow until “Rings Required” is displayed, factory default is “005” press NO
and change to 001, press YES
Press menu followed by down arrow to “Setup Modules” press YES
Press down arrow until “Modem Speed” is displayed. Ensure this is set to 2400, if not
press NO until 2400 is displayed then press YES
Press menu followed by the down arrow until “Com Port Setup” is displayed, press YES
“Onboard Digicom (Com300 Module)” is now displayed, press NO then down arrow
until “Com2400 Module” is displayed, press YES
Unit is now setup for UDL
Things to consider on installation
Make a note of the panel’s Make, Model and Vers
E.G. Elite, 48, version x2
This information is critical when setting up a file in Wintex from where ever your UDL
connection is being made from

If you require any further assistance please contact
CSL Technical Support: [phone]
Ian Hardisty: [phone]