Custom Dynamics MPR-MICROAW-18ST User manual
Custom Dynamics® Micro Turn Signal Adapter
Installation Instructions
Questions? Call us at: 1 (800) 382-1388 M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST
02-2022
We thank you for purchasing the Custom Dynamics® Micro Turn
Signal Adapter. Our products utilize the latest technology and
high quality components to ensure you the most reliable service.
We offer one of the best warranty programs in the industry and we
back our products with excellent customer support, if you have
questions before or during installation of this product please call
Custom Dynamics® at 1(800) 382-1388.
Package Contents:
- Micro Turn Signal Adapter (2)
Part Numbers:
Fits: 2018-2022 Harley-Davidson® Softail® Models
Warning: Disconnect negative battery cable from battery; refer to owner’s
manual. Failure to do so may result in electrical shock, injury, or fire. Secure
negative battery cable away from positive side of battery and all other posi-
tive voltage sources on vehicle.
Safety First: Always wear appropriate safety gear including safety glasses
when performing any electrical work. It is highly recommended that safety
glasses be worn throughout this installation process. Be sure vehicle is on
level surface, secure and cool.
Important: This product is designed and intended for use as auxiliary light-
ing only. It is NOT intended to replace any original equipment lighting in-
stalled on the vehicle and should not be used for that purpose. This product
must be wired so that it does not interfere with any original equipment light-
ing.
ATTENTION
Please read all Information below before Installation
MPR-MICROAW-18ST
1
Installation:
1. Disconnect the negative battery cable from the bat-
tery.
2. Refer to the factory service manual and remove the
gas tank from the bike.
3. Locate and remove the terminal rubber boot cover
from the front left side of the frame exposing the termi-
nal block, refer to Photo 1.
Questions? Call us at: 1 (800) 382-1388 M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST
10/2020
Installation Instructions - Page 2.
4. Disconnect the left and right front turn sig-
nal lighting harnesses from the terminal
block connector. Refer to Photo 2.
5. Connect one of the Micro Turn Signal
Adapter harnesses in-line with the bike’s
front RIGHT turn signal lighting harness
and the terminal block connector. Connect
one of the Micro Turn Signal Adapter har-
nesses in-line with the bike’s front LEFT
turn signal lighting harness and the termi-
nal block connector.
6. Carefully tuck the Micro Turn Signal Har-
nesses into the backbone cavity and re-
mount the terminal block along with the
terminal block rubber boot. Be sure to
leave the Female connectors of the Micro
Turn Signal Harnesses outside of the rub-
ber boot as shown in Photo 3.
7. Connect the Micro Turn Signals (Sold Sep-
arately) to the installed Micro Turn Signal
Adapters.
8. Secure wires to prevent the wires from be-
coming cut, frayed, or pinched.
9. Reconnect the negative battery cable to
the battery and reinstall the seat.
10.Test operation of all lighting before riding.
3
2
