Customtronix RA3 User manual

2014-04-23
RA3 and RA4 reinstallation and set-up guide.
Information and troubleshooting
1. Only upgrade radio with our software, issued by us. Read update manual.
2. If the na igation is stuck in France (Paris) for more than 10 minutes, after reinstalling
the system back in the car, a reset is required. To a oid problems later on we
recommend you to always do a factory reset after reinstalling the system e en if
na igation seems to be running without any problems.
How to access the "Engineering Menu" to ma e a Reset To Factory Default...
3. Press 2 buttons simultaneously. Press/hold down the Red "temp up" key (1) and the
Blue "temp down" key (2) on the dri er side for 5 seconds.
Continuing next page
1 (4)

2014-04-23
The "Engineering Menu" will come up, scroll (3) down to "Reset To Factory
Defaults" (4), press "Yes". Wait approximately one minute for the system to reboot.
Pic below show lower part of the ”Engineering menu”.
The best way to initialise a car after a factory reset is to remo e the positi e cable from
the cars battery for 5 minutes.
Re-connect the positi e cable to the battery and turn ignition ”On” and let the system
boot-up completely, then turn ignition ”Off” open and close the door and wait for
approximately 1 minute for the car to shut down, this is to initialise all the modules and
dri ers for the different hardware's, done.
DO NOT play around with the settings in the ”Engineering Mode” as it can oid the
warranty.
4. The FM-radio part has only Odd frequencies on following models MX,CA and NA, so if
you manually tune for "e en" frequencies it will not respond.
5. If you ha e problem with you pin-code, remember that the pin-code is on the note
attached on top of the unit when it is returned after con ersion.
6. For authorised Chrysler dealers It´s possible to check the pin-code from the serial
number of the na igation unit in the ERES system (Chrysler Electronics Repair &
Exchange System). To do that you must access ”Dealer Mode” (a different menu
system separate from the ”Engineering Mode”).
Continuing next page
2 (4)

2014-04-23
To access ”Dealer mode” for chec ing the serial number.
7. Press/hold down the:
On the dri er side press and hold down
Red "temp up" key (1)
Blue "temp down" key (2) on the dri er side.
On the passenger side press and hold down
"Defrost front" key (3)
All abo e keys must be pressed simultaneously for 5 seconds.
The "Dealer Mode” Menu will come up.
Press "System Information".
Continuing next page
3 (4)

2014-04-23
Then press "Radio Part Information" the information of the unit will show right down
the serial number that starts with "TOOBE*********" like TOOBEAF5012456
Disclaimer and support.
•Don't open the na igation. If the oid
sticker is broken we will not gi e you any
warranty on our work.
•Repair or Programming of the system
should only be done by qualified
personal in sterile en ironment.
•You may contact our support on:
Our RA4/3 lab programming station.
4 (4)