CVS VC58SMi User manual

VC58SMi
1.3 Megapixel IP Camera
Manual ver.0.2(2010.11.02)

VC58SMi USER MANUAL
-1-
Precautions
Please read the manual carefully before the installation in order to make use the
camera to be set up correctly and to have the best picture quality.
·Please keep the manual in good condition for your future reference and service
application.
·Installation and services should only be carried out by an authorized personnel
according to local safety regulations.
·If any liquid or solid matter gets into the housing, immediately disconnect the camera
from power supply and have it checked by your authorized dealer before reusing.
·Avoid installing the camera at extremely hot or cold places.
·If you are not a certified person, never try to dismantle the camera. To avoid electric
shock, never remove the screws or covers. There are no parts inside that need
maintenance by the user. All maintenance should be carried out by qualified
personnel.
·Avoid installing the camera at a place of high humidity.
·Avoid installing the camera at the place exposed to gas or oil.
·Keep the top glass of the lens always clean in order to obtain the best picture quality
all the time. Be careful not to be stained by fingerprint.
·Don't face the camera directly toward sunlight or sunlight reflecting area.
CMOS may go defective at this condition.
·Please give a special attention to keep the unit from dangerous drop or
external shock during the process of transportation or handling.
·Never try to touch the camera in wet hand. It may cause an electric shock.
·Do not expose the camera to radioactivity. It causes a serious damage on the CMOS.
Congratulations on your purchase of this product. Read this
manual carefully and keep it in a safe place for future reference.

VC58SMi USER MANUAL
-2-
Table of Contents
1. introduction.................................................................................................................
1. about installation manuals ..................................................................................... 3
2. features .............................................................................................................. 3
3. package contents................................................................................................. 4
4. product view........................................................................................................ 5
5. system connect ................................................................................................... 7
2. installation ................................................................................................................ 9
1. connecting to a network(LAN) ................................................................................ 9
2. connecting audio ................................................................................................. 9
3. connecting sensor & alram .................................................................................... 9
4. connecting power ................................................................................................ 9
5. initial indicators.................................................................................................... 9
3. getting started ........................................................................................................... 9
1. remote image view ...........................................................................................10
2. Live view.........................................................................................................11
3. Menu ...............................................................................................................17
4. CAMERA SETUP ..............................................................................................20
5. EVENT SETUP .................................................................................................28
6. USER SETUP...................................................................................................32
7. NETWORK SETUP ............................................................................................35
8. SYSTEM SETUP ...............................................................................................47

VC58SMi USER MANUAL
-3-
1. Synopsis
1. about this article
This manual explain how to use VC58Mi model that high quality network camera
Throughout this article, can be found that how to install VC58Mi, Set according to the environmental
changes, and how to Diagnostic error
2. features
Based on open IP standards, VC58Mi connect to any kind of IP network, including the Internet, and enable
remote viewing and recording from anywhere in the world. They also provide advanced video analytics
features, such as motion detection, audio detection and tampering alarm.
video
-Multiple H.264 & MJPEG streams
-Multiple image resolution: CIF (320x240) ~ HD (1280x720)
-Support bit Rate: CBR, VBR
-Motion detection
-Support COMPOSITE Video out
Audio
-Support Audio streaming Two-way
Network
-Support static IP & IP(DHCP)
-Support multi connection
-Supported protocol : TCP/IP, UDP, DHCP, SMTP, HTTP, RTP, RTSP)
Seriel Data
-Support RS-485
Sensor & Alarm
-Support Sensor & Alarm terminal

VC58SMi USER MANUAL
-4-
-If system is failure it will be trigger alarm
User interface
-Support remote setting, analysis, & update
-
SD Memory
-SD memory Card recording , remote search & play
High stability
-Based on imbedded system
-Watch-dog
3. package contents
VC58Mi Quick Guide S/W & installation CD
C-Mount Adaptor Auto Iris Plug 1EA

VC58SMi USER MANUAL
-5-
4. Product views
①Protective cover
②C-Mount lens adaptor
③DC Iris Jack
④Mounting bracket holder
Mounting bracket holder can be
separated and attached on the
bottom side as well.
Please use the supplied clamp
screws only change the position
of the bracket. Using screws more
than 5mm depth can do a serious
damage to the inside this camera.

VC58SMi USER MANUAL
-6-
Rear
Connector
Function
1. LAN/802.3af
LAN port/802.3af
LED : indicate status of Power, network communication
2. AUDIO OUT
Audio output
3. AUDIO IN
Audio input
4. RESET Button
Factory Default
5. POWER IN
DC 12V
6. SENSOR/ALARM
Sensor input / relay out
7. COMPOSITE OUT
COMOSITE video out
8. SD CARD
SD memory card
①
②
③
④
⑤
⑥
⑦
⑧

VC58SMi USER MANUAL
-7-
2. INSTALLATION
1. CONNECTING NETWORK(LAN)
There is video output to check the video After connecting power & LAN connection
2. Connecting Audio
If necessary connect Audio
3. Connecting Sensor & alarm
Connect sensor and Alarm(relay).
4. Connecting Power
Connect the power adapter to the DC-IN socket on the camera
.
5. Initial indicators
It takes time about 1min. for initial
3. System operation
1. Remote view
If VC58Mi and center system are connected there are two way you can see.
The system's IP address must be set correctly
Using an Internet Browser to Connect to the Camera
Read this section to learn how to use your Internet browser to connect to the IP camera, view images, and
hear audio output.
Default ID : admin Password : 1234

VC58SMi USER MANUAL
-8-
To connect to the IP camera using an Internet browser:
Enter the IP address of the camera in the browser address field.
.
☞All items on the web page can be used after the authentication process
[Picture 1] LOGIN
○
1ID / PASSWORD INPUT
ID: MAX 16characters available English & Number
PASSWORD: MAX 16characters available English & Number
To manage register & delete of ID/PASSWORD go to Setup>User> User Account Menu
If you do not have permission it will be show error message and can`t access
http://192.168.1.100
○
1
☞[note]
- if you do not have the loading during over 30 minutes it will be logout
automatically
- The password is stored by the encryption algorithm
- If authentication fails, error message output on the bottom of the window

VC58SMi USER MANUAL
-9-
2. Live
[Picture 2] LIVE Monitoring
○
1
○
2
○
3
○
4
○
5
○
6
☞[Main feature]
- Live monitoring
- fixed/original image size
- PTZ
- Screen Shot, Two-way Audio (Speaker/Mic)
- OSD On/Off
- Alarm Out
- UPNP(Universal Plug and Play) On/Off
- Network Status (LAN/WIFI)
- Storage
- help & support