DèLonghi KBO Series User manual

De’Longhi Appliances via Seitz, 47 31100 Treviso Italia www.delonghi.com
5721010051/09.15

KBO Series
KETTLE
Instructions for use
BOUILLOIRE
Mode d’emploi

KBZ2001
BOLLITORE
Istruzioni per l’uso

KBZ2001
BOLLITORE
Istruzioni per l’uso

2
ELECTRICAL CONNECTION UK ONLY
A) If your appliance comes tted with a plug, it will incorporate a 13 Amp fuse. If it does not t your socket, the plug should be
cut o from the mains lead, and an appropriate plug tted, as below. WARNING: Very carefully dispose of the cut o plug
after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard.
With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse. If the plug is a moulded-
on type, the fuse cover must be re-tted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the
event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest
electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug.
B) If your appliance is not tted with a plug, please follow the instructions provided below:
WARNING -THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accordance with the following code:
Green and yellow: Earth
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your
plug, proceed as follows:
The green and yellow wire must be connected to the terminal in the plug marked with the letter E or the earth symbol
or coloured green or green and yellow. The blue wire must be connected to the terminal marked with the letter N or coloured
black.
The brown wire must be connected to the terminal marked with the letter L or coloured red.
EN FR SA
page 4 page 8 2


3
A
B
C
D
F
G
H
E

4
INTRODUCTION
Thank you for choosing a De’Longhi product. Please take
a few moments to read the instructions to avoid risks or
damage to the appliance.
Symbols used in these instructions
Important warnings are identied by the symbols below.
It is important to respect the warnings. Failure to respect the
warnings could lead to electric shock, serious injury, burns,
re or damage to the appliance.
Danger!
Failure to observe the warning may result in life threatening
injury by electric shock.
Important!
Failure to observe the warning could result in injury or
damage to the appliance.
Danger of burns!!
Failure to observe the warning could result in burns or
scalds.
Please note:
This symbol indicates recommendations and important
information for the user.
IMPORTANT WARNINGS
Safety warnings
Danger!
- Avoid spillage on the connector.
Important!
- The appliance is exclusively for the
use of boiling water. Any other use
is to be considered inappropriate
and therefore dangerous. The
manufacturer cannot be held
responsible for eventual damage
caused by inappropriate, improper or
irresponsible use and/or for repairs
made to the product by unauthorised
personnel.
- The appliance is designed and
produced for domestic use only. It is
not suitable for use in: sta kitchens in
shops, oces and other workplaces,
farm houses, hotels, motels or other
holiday accommodation, guest
houses.
- This appliance can be used by children
aged 8 upwards and by persons with
reduced physical, sensory or mental
capabilities or who lack of experience
and knowledge if they are supervised
or have been given instructions
concerning use of the appliance in a
safe way and understand the hazards
involved.
Children must not play with the
appliance. Cleaning and user
maintenance must not be carried out
by children unless they are older than
8 and supervised. Keep the appliance
anditscordout of the reachofchildren
under 8 years of age.
- The power cable must not be replaced
by the user as this requires the use of
special tools.
If the supply cord is damaged, it must
be replaced by the manufacturer, its
service agent or similarly qualied
persons in order to avoid a hazard.
-Use the kettle only with the power
base supplied (and vice versa).
- Do not operate the kettle on an
inclined surface.
- Do not operate the kettle unless the
element is fully immersed.
- To prevent damage to the appliance
do not use alkaline cleaning agents
when cleaning, use a soft cloth and a
mild detergent.
Danger of burns!!
-Do not remove the lid while the kettle

5
is boiling.
- If the kettle is overlled, boiling water
may overow.
- The heating element surface is subject
to residual heat after use.
Please note:
- Never move the kettle while it is in
use.
Danger!
- To protect against electrical hazards do not immerse
the mains lead, plug power base or kettle in water or
any other liquid. Do not use in the bathroom or near
any source of water. Do not use outdoors.
- Remove the plug from the mains socket when not
in use and before cleaning. Allow the kettle to cool
before cleaning.
- Do not use the kettle if you have wet hands.
- Do not place any utensils into the kettle.
The use of accessory attachments not recommended by
the appliance manufacturer may result in re, electric
shock or personal injury.
Important!
- Take care when pouring - do not over-tilt the kettle as
water may enter into the switch mechanism.
- Close supervision is necessary when any appliance is
used near children.
- Do not operate this kettle if the mains lead or plug
is damaged, if the kettle malfunctions, or has been
damaged in any manner. It must be returned to an
authorised service agent for repair or replacement in
order to avoid hazard.
Danger of burns!!
- Do not touch hot surfaces i.e. body or lid. Use handles
or knobs.
- Water can remain hot for a long time after boiling and
can present a scald hazard. Keep the kettle and the
mains lead away from the edge of the work surface
and out of the reach of children.
- Do not allow the mains lead to hang over the edge of
the table or work surface.
- Avoid contact with steam coming out of the spout
when pouring, and out of the lid or spout when
relling.
- Keep the kettle, the power base, and the mains lead
away from hotplates, hobs or burners.
Please note:
- Remove the kettle from its power base before lling.
- Do not use the kettle for any purpose other than
heating water.
- De’Longhi will not accept any liability if the appliance
is subject to improper use, or failure to comply with
these instructions.
- Never use the kettle without its lid and lter.
- Position the kettle properly on the power base before
switching on.
This appliance conforms to EC Regulation 1935/2004
on materials and articles intended to come into contact
with food.
Disposing of the appliance
The appliance must not be disposed of with
household waste, but taken to an authorised waste
separation and recycling centre.
DESCRIPTION
ARemovable lter
BRemovable lid
CKettle body
D Power-on indicator lights
E360° base with cord storage
FPlug
G ON/OFF switch
HWater level indicator
USE
Before use
- Remove all packaging from the kettle and power base.
- Remove any labels from the outer stainless steel
surfaces.
- Remove the lter (g. 1) and wash with water (g. 2).
Refer to “Removing the scale lter”.
- Fill the kettle and boil.
12

6
- The boiled water should be discarded and the kettle
rinsed out with cold water. This procedure should be
carried out three times, to remove any manufacturing
dust, etc.
- After the kettle has been rinsed out, re-t the lter (g.
3).
In use
With the specially designed power base and central
connector, you can now set the kettle on the base at any
angle, from any position.
- Release cord from storage
base and adjust length by
winding around the base to
give the correct cord length
to reach the plug socket to be
used (g. 4).
- Do not leave loose cord
hanging over the edge of
work surfaces.
Filling
- Remove the kettle from the base unit before lling.
- Open lid and ll kettle to desired level.
Do not ll with less than 0,3 litre of water to
prevent the kettle running dry while operating; misuse
of this kind will shorten the life of the element.
Do not ll with more than 1.7 litres of water (up
to the MAX level).
If the kettle is overlled, there is a risk that
boiling water may be ejected causing burns.
Switching on
- Plug the power base into the mains socket.
- Place kettle on power base.
- Press the ON/OFF switch
down (g. 5) to switch the
kettle on.
- The pilot light will switch
on.
- Thekettle willautomatically
switch o once the water is
boiled (the ON/OFF switch will click upwards and the
lights will switch o ).
- To turn the kettle o before the water boils, you may
move the ON/OFF switch up to the OFF position, or
simply lift the kettle from its base - it will switch
o and the switch will return to the OFF position
automatically.
Pouring
- Remove the kettle from the power base and carefully
pour out the water. Do not tilt the kettle suddenly or
pour water out at too sharp an angle.
- When you lift the kettle from the base, you may see
moisture on the top surface of the base. Condensation
on the base is perfectly normal, and should not be a
cause for alarm.
SAFETY DEVICES
1) Automatic ON/OFF switch:
Your kettle is tted with an ON/OFF switch which
automatically switches o once the water has boiled.
If the kettle has just boiled, wait a minute or so before
re-boiling the kettle. Do not attempt to hold the ON/
OFF switch in the on position or adjust the switch
mechanism.
2) Safety cut-out:
If the kettle is switched ON with too little or no water, it
is protected against damage by a safety cut-out which
will switch o the power. If this cut-out operates,
disconnect the kettle from the mains supply and
leave to cool down before relling with cold water
(otherwise the element could be damaged).
3) If kettle is lifted from base while operating (ON), it will
automatically switch o.
MAINTENANCE
Cleaning the kettle
- Allow the kettle to cool down fully and disconnect the
appliance from the mains before cleaning.
- Do not immerse the kettle or base in water.
- Use a soft dampened cloth to wipe the outside of the
kettle and dry with a soft, dry cloth.
- DO NOT use metal polish or harsh scouring agents.
- Ensure that all connectors and sockets are kept dry.
Scale
Scale is mainly calcium carbonate (chalk), a harmless,
naturally occurring mineral found in most water supplies.
“Hard”water contains more of this mineral than“soft”water.
5
3
4

7
When the water is heated, the minerals in the water solidify,
making the water appear cloudy. These minerals form a
thin lm on the walls, element and on the surface of the
water. The water may look like it has white coloured pieces
of plastic oating on the surface. On traditional kettle
elements, scale forms a hard white “crust” which adversely
aects performance and reduces the life of the element. As
soon as you notice a lm forming on the water, or, when
cleaning the lter, if you notice a lm on the walls or the
element, simply rinse the kettle and wipe it out.
Scale lter
Your kettle is tted with a scale lter to prevent loose
particles of scale being poured into your beverage.This lter
is both removable and washable.
The frequency with which you will need to clean any scale
deposits from your lter will depend on the hardness
of water in your area and how often you use the kettle.
You should remove and clean the water lter when you
notice any deposits being left on the lter or if the pouring
eciency is impaired.
Removing the scale lter
- Allow the kettle to cool down fully.
- Disconnect the appliance from the mains electrical
supply.
- Make sure that your hands are clean and free from
soap, cream or anything which might taint the water.
- Empty the kettle and remove the lter as shown in g.
1.
- Rinse under a tap whilst brushing with a soft brush (g.
2).
- Replace the lter (g. 3).
To clean the scale lter
It is vital to clean and descale regularly in order to maintain
good working order
- Use descaler for kettles. When limescale starts forming
on the heating element, buy a suitable descaler
and descale according to the instructions given on
the descaler pack. After descaling, boil the kettle
repeatedly with fresh water and rinse thoroughly to
completely eliminate all residues of descaler which
could damage the appliance. If the lter requires
descaling, remove and immerse in the same descaling
solution.
- Make sure electric parts are completely dry before
using the kettle.
TECHNICAL CHARACTERISTICS
Power supply See rating plate
Absorbed power “