
3
el e C t r o n i C Co n t r o l Ce n t e r
init i a l te M p e r a t U r e se t t i n g s
Temperatures are preset at 37° F (3° C) in the fresh food
compartment and 0° F (-18° C) in the freezer compartment. The
display will show the average compartment temperatures, based
on several measurement points within the compartment.
Note:
Temperatures displayed may vary from set point due to door
openings or during defrost. Thermometers placed in the
refrigerator may record a temperature slightly above or below
the displayed temperature. This is normal as the displayed
temperature is an average.
te M p e r a t U r e ad j U s t M e n t s
• Allowthetemperaturetostabilizefor24hoursafterloadingthe
refrigerator before making any temperature adjustments.
• Thefirsttouchoftheupordownarrowshowsthecurrent
temperature set point.
• Subsequenttouchesofthe pad raise the temperature set
point or the pad lowers the temperature set point.
• Thedisplaywillshowthenewsetpointforapproximatelythree
seconds, then return to the actual temperature currently within
that compartment.
• Limittemperaturechangestoonedegreeatatime.Allowthe
newtemperaturestostabilizefor24hoursbeforemakinganew
temperature adjustment.
fa s t iC e
When activated, Fast Ice reduces the freezer
temperaturetotheoptimumsettingfor24hoursin
order to produce more ice.
Note:
When the Fast Ice feature is in operation, the and pads for
the freezer control will not operate.
re s e t fi l t e r
When a water filter has been installed in the
refrigerator, the yellow Alert light will illuminate
when 90 percent of the volume of water for which the filter is rated
has passed through the filter OR 11 months have elapsed since
the filter has been installed.
The control center is located at the top front of the fresh food compartment.
The red Change light will illuminate when the rated volume of
water has passed through the filter OR 12 months have elapsed
since the filter was installed. A new filter should be installed
immediately when the Change light is illuminated.
After replacing the filter, press and hold the Reset Filter pad for
three seconds. The Alert and Change lights will go off.
ab s e n t Mo d e
The Absent Mode feature causes the freezer to
defrost less frequently, conserving energy. The
Absent Mode indicator light will illuminate when the feature is
activated. To deactivate, press the Absent Mode pad again OR
open either door. The indicator light will go out.
Notes:
• DooropeningswillnotdeactivateAbsenceModefor
approximately one hour after activation.
• Ifvacationingformorethanafewdays,seethePreparingfor
Absent section, page 16.
te M p al a r M
The Temp Alarm system will alert you if the
freezer or fresh food temperatures exceed normal
operating temperatures due to a power outage or other event.
When activated, the Temp Alarm light will illuminate.
If the freezer or fresh food temperatures have exceeded these
limits, the display will alternately show the current compartment
temperatures and the highest compartment temperatures reached
when the power was out. An audible alarm will sound repeatedly.
Press the Temp Alarm pad once to stop the audible alarm. The
Temp Alarm light will continue to flash and the temperatures will
alternate until the temperatures have stabilized.
To turn off Temp Alarm, press and hold the Temp Alarm pad for
three seconds. The indicator light will go off.
do o r al a r M
The Door Alarm will alert you when one of the
doors has been left open for five continuous
minutes. When this happens, an audible alarm will sound every
few seconds until the door is closed OR press the Door Alarm pad
to deactivate the feature.