Dametric CEC-DM1 User manual

Dametric AB CEC-DM1 CAN-Ethernet-Converter
CEC-DM1 EN.docx June 2, 2008 Page 1 (3)
CEC-DM1
CAN /ETHERNET CONVERTER MODULE
FOR THE GMS SYSTEM
USER MANUAL
dametric

Dametric AB CEC-DM1 CAN-Ethernet-Converter
CEC-DM1 EN.docx June 2, 2008 Page 2 (3)
Table of contents
1GENERAL ...................................................................................................................................................2
2TECHNICAL SPECIFICATION...................................................................................................................2
3CONNECTION DIAGRAM ..........................................................................................................................2
4TROUBLESHOOTING................................................................................................................................3
5CONTACT ...................................................................................................................................................3
1 General
The CEC-DM1 is a converter module between the CAN bus and the Ethernet network.
It is used in the GMS measuring system for data exchange between the RMS/GMS units and the control
software in a Panel PC. The IP-based protocol uses the UDP transport layer for data exchange.
Each unit has a unique MAC-address and the configurable IP-address. The software in the Panel PC is set up
to exchange data to a specified IP-address.
The unit is powered with 24Vdc.
2 Technical Specification
Metso part no: VAL0219209
Supply voltage: 24 VDC, ± 10 %.
Power consumption: Nominal 0.1A, Max. 0.2A.
CAN: Up to 1Mbit baudrate, 4-pole jackable screw connector.
Ethernet; IP-based, UDP-protocol, RJ45 connector.
Module size: Height=110 mm, Width=23 mm, Depth=115 mm.
Closure: Polycarbonate (30%GV), DIN-rail mounting.
Connections: Plug-in screw connectors, max 2.5mm2 cable areas.
3 Connection Diagram
K1 +24VDC
K1/1 +24VDC The power supply (internally connected to K1/2)
K1/2 +24VDC The power supply (internally connected to K1/1)
K1/3 0VDC The power ground (internally connected to K1/4)
K1/4 0VDC The power ground (internally connected to K1/3)
K2 CAN
K2/1 CAN-H CAN-interface H-signal (use twisted pair cable for CAN-H and CAN-L)
K2/2 CAN-L CAN-interface L-signal
K2/3 CAN-R CAN-interface, connect to K2/2 for 120Ωtermination
K2/4 0VDC The power ground (internally connected to K1/2 and K1/3)
K3 Ethernet
K3 Ethernet RJ-45 connector

Dametric AB CEC-DM1 CAN-Ethernet-Converter
CEC-DM1 EN.docx June 2, 2008 Page 3 (3)
4 Troubleshooting
Two leds can be found beside the Ethernet connector on the lower side of the unit.
The green ETHERNET led.
The led flashes at 1Hz when the Ethernet traffic occurs.
Check the Ethernet connection if the led never lits.
The yellow CAN led.
The led flashes at 1Hz when the CAN traffic occurs.
Check the CAN connection if the led never lits.
5 Contact
Sales, development, production and service:
Dametric AB
Jägerhorns Väg 19, SE 141 75 Kungens Kurva, Sweden
Phone: [phone] Telefax: [phone]
E-Mail: [e-mail] Website: www.dametric.se
dametric