Danfoss AK-XM 208B User manual

Instructions
Replace of old AK-XM 208B
with AK-XM 208C
RI8SS102 04-2019
• AK-XM 208C can be used as spare part for AK-XM 208B.
• AK-XM 208C opens and closes opposite the AK-XM 208B.
• There is no need to change settings.
Info
Old installation
with AK-XM 208B
New connections
with AK-XM 208C
Filter AKA 211 must not be used.
Assure correct function by swapping two wires.
Remove the filter AKA 211 if installed
Remove AK-XM 208B
L = max. 100 feet. (30 m)
27↔28
31↔32
35↔36
39↔40

2 Instructions RI8SS102 © Danfoss 04/2019 AK-XM 208C
ADAP-KOOL®
The Product contains electrical components
And may not be disposed together with domestic waste.
Equipment must be separate collected with Electrical and Elec-
tronic waste. According to Local and currently valid legislation.
Check the
correct open/close function
1. Remove the power supply to
the communication module
AK-CM 101A
2. Check the valve is closeing
(If it is already closed, it will remain closed)
3. Connect the power supply again.
By reconnecting power to the AK-CM 101A
module the stepper module start calibrating
the valve to closed position.
If wires are wrongly connected the valve is
opening to 100%.