Datalogic Magellan 8500Xt Reference guide

Installation Procedure and Product Handling
Operator Buttons and Indicator LEDs
Diagnostic Error Display
Escalation Support Options
*Volume/Tone Button
Scale Zero Button
**EAS Button
Scan LED
EAS LED
Scale LED
Datalogic Scanning Tech Support
541-683-5700 (USA only)
6:30am - 5:00pm Pacic Time
Monday thru Friday
Contact your nearest Datalogic Support
Center. For a full listing of Datalogic
Support Centers and documentation:
www.scanning.datalogic.com
1. Unpack the Magellan 8500Xt from the shipping carton.
2. Remove the top platter and supporting foam.
3. Make necessary cable connections between the scanner/
scale, remote display, POS terminal and power source. (See
“Cabling” on the other side of this sheet.)
4. Install the scanner/scale in-counter in the orientation and
position described. Conrm scanning and weighing func-
tions.
5. Calibrate and certify the scale per state and local Weights
and Measures requirements.
6. Install the top platter, remove the protective vinyl sheet
from the glass and wipe down both windows.
When moving the unit, use the lift handles seated beneath
the top platter, down inside the chassis, and must be ro-
tated up as shown.
DO NOT ATTEMPT TO LIFT THE PRODUCT BY THE BONNET.
Magellan™ 8500Xt QUICK REFERENCE CARD
*Hold Volume/Tone Button down for 10 seconds
to reset the scanner/scale and initiate self test.
**EAS is optional (not present on all models).
The diagnostic error display is located left of the motor/
facet wheel, visible through the horizontal window.
NOTE: Error codes displayed should be supplied with unit serial number when making RMA request to manufacturer.
CODES ACTION
.0 or .1 Check POS connections & programming (see
PRG), then call Datalogic Tech Support.
.7 See “Scale Error Reporting” in PRG, then call Data-
logic Tech Support.
.8 Check Remote Display (see PRG) then call Data-
logic Tech Support.
.9 Check EAS cable, then call Datalogic Tech Support.
.C Recalibrate scale (see PRG), then call Datalogic
Tech Support.
.2 thru .6,
.A, .B, .E, (.) Call Datalogic Tech Support
See the Magellan 8500Xt Product Reference Guide (PRG) for detailed instructions on these procedures.

Cabling
Mounting
EAS
Antenna
Aux.
Port
Scale
Host
Port
POS
I/F
Remote
Scale
Display
EAS
Interlock
Power
Scanner/Scale Connector Panel
Magellan™ 8500Xt
The product must be mounted in the counter in a
stable position. Check to ensure that it does not
rock or “teeter” from side-to-side or corner-to-
corner on any axis.
NOTE:
For full product installation instructions, dimensions
and requirements, refer to the 8500Xt Product
Reference Guide (PRG), available on the Datalogic
Scanning website at www.scanning.datalogic.com
Height Adjustment
R44-3122 (Rev A)
Trailing Edge Leading Edge
Left-Hand Take-Away Installation
(reverse for Right-Hand Take-Away)
Side Rail
Scale Platter
Counter
(or Dead Plate)
Product Flow
R44-3122
©2010 Datalogic Scanning, Inc.