DAVIS Vantage Pro2 Updater User manual

Connecting a Davis Vantage Pro 2 or Vue to Weather Underground Using a
Weatherlink IP Device
Complete installation of your weather station.
● Davis Support installation diagrams and instructions
Connect the Weatherlink IP device to the Vantage Vue or Vantage Pro 2
console.
Connect the Weatherlink IP to the Internet (plug it in to your router).
● Installation diagram for Vantage Pro 2.
● Installation diagram for Vantage Vue.
Create a free Weatherlink account at www.weatherlink.com.
Click the Add Devices button at the top right corner of the
Weatherlink website.
On the device menu, click the Install button in the
WeatherlinkIP section.
Enter your Station Name. Select the weather station Model. Identify your
Station Usage. Enter your Device ID. Enter your device Key.
● Both the Device ID (DID) and Key are found on the sticker attached to the Weatherlink IP device.
Confirm your station is communication with the Weatherlink website.
● Verify data appears on the website.
●Helpful Tip:  If no data appears, power cycle the display console after connecting the Weatherlink
IP device.

Connecting a Davis Vantage Pro 2 or Vue to Weather Underground Using a
Weatherlink IP Device
Create a free account on the Weather Underground website:
www.wunderground.com.
Click Sensor Network on the Weather Underground home page.
Select Connect a Weather Station in the drop-down menu.
Click Add a New PWS (personal weather station).
● If there are other weather stations connected already, you may have to scroll to the bottom of the
page to locate the Add a New PWS button.
Identify your weather station’s location using the map and click Verify
Location.
Enter required information and click Submit. If done correctly, this will
generate a Weather Station ID and a Station Key. Write down both the
Station ID and Station Key from Weather Underground.
Return to the Weatherlink website and click the Share & Uploads button.

Connecting a Davis Vantage Pro 2 or Vue to Weather Underground Using a
Weatherlink IP Device
Click the Upload button and enter the weather station information
from Weather Underground.
Click Add Upload .
Select Weather Underground from the drop-down list.
Enter the necessary information and click Upload.
Navigate back to the Weather Underground website to verify that your
Davis station is communicating with Weather Underground.

Connecting a Davis Vantage Pro 2 or Vue to Weather Underground Using a
Weatherlink IP Device