davoline DQ078 User manual

FAN HEATER
OPERATING INSTRUCTIONS
MODEL NO.: DQ078

IMPORTANT SAFEGUARDS
When using an electrical appliance, basic safety precautions should always be
observed, including the following:
READ ALL INSTRUCTIONS BEFORE USING
WARNING: To reduce the risk of fire, electrical shock, or injury to person:
1. The product is for household use only.
2. Connect the appliance to single-phase AC supply of the voltage specified on the
rating plate.
3. In order to avoid overheating do not cover the heater.
4. The meaning of figure in marking is “DO NOT COVER”.
5. Never leave the heater unattended while it is in use. Always turn the product to the
OFF position and unplug it from the electrical outlet when not in use.
6. Extreme caution is necessary when any heater is used by or near children, invalids
or elderly person and whenever the heater is left operating and unattended.
7. The heater must not be located immediately below an electrical socket-outlet.
8. Do not run cord under carpeting and do not cover cord with throw rugs, runners or
the like. Arrange cord away from traffic area and where it will not be tripped over.
9. Do not operate the heater with a damaged cord or plug, or after the heater
malfunctions, has been dropped, or damaged in any manner.
10. If the supply cord is damaged, it must be replaced by the manufacturer, its service
agent or a similarly qualified person in order to avoid a hazard.
11. Avoid the use of an extension cord as this may overheat and cause a risk of fire.
12. Use the heater in a well-ventilated area. Do not insert or allow objects to enter
any ventilation or exhaust opening. To prevent a possible fire, do not block air intakes
or exhaust openings in any manner. Do not use on soft surfaces, like a bed, where
openings may become blocked. Use the heater on flat, dry surfaces only.
13. Do not place this heater near flammable materials, surfaces or substances, as
there may be a risk of fire. Keep the above flammable materials, surfaces or
substances at least 1m from the front of the product and keep them away from the
sides and rear.
14. Do not use the heater in any areas where petrol, paint or other flammable liquids
are stored e.g. Garages or workshops as a hot, arcing or sparking parts inside the
heater.
15. Don’t use this heater in the immediate surroundings of a bath, a shower or a
swimming pool. Never locate the heater where it may fall into bathtub or other water
container.
16. This heater is hot when in use. To avoid burns and personal injury, do not let bare
skin touch hot surfaces. If provided, use handles when moving the product.

17. Be sure that no other appliances are in use on the same electrical circuit as your
product as an overload can occur.
18.This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
19.Children should be supervised to ensure that they do not play with the appliance.
FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
SPECIFICATIONS
MODEL NO RATED VOLTAGE RATED POWER
DQ078 220-240V~ 50/60Hz 1800W
STRUCTURE AND PARTS
1
5
2 1.Thermostat
2.pilot light
3.air outletmesh
4.front cover
5.select switch & oscillating switch
6.back cover
INSTRUCTIONS FOR USE
1. Before using the heater make sure that it is on a flat and stable surface, Damage
may occur if it is placed on an incline or decline.
2. Turn off all the controls of the heater, and then plug the heater power plug directly
into a standard AC outlet. Be sure plug fits tightly into outlet.
3. Rotate the thermostat regulator clockwise to the position max, then rotate the
power switch regulator from 0 (OFF) to (fan) to activate the wind-motor, and check
if it acts normally.
4. Rotate the power switch regulator from (fan) to I(low) or II (high) to choose the
desired power, I(low) for 900W and II (high) for 1800W
5. When the desired temperature is reached, rotate the thermostat regulator counter
clockwise until the pilot light goes off. The desired temperature will be kept constant
by the thermostat.
6. If you want to enlarge heating area in your room, turn on the oscillating switch, the
3
3
4 6

heater will oscillate automatically and heat your room in large scope.
7. This heater includes an overheat protection system that shuts off the heater when
parts of the heater are getting excessively hot.
8. Your heater is designed to automatically shut-off when tipped forward or backward.
When returned to normal upright position, heat will automatically come on again. This
is a safety feature to avoid possibility of fire should the unit be accidentally upset.
9. To completely shut the heater off, turn all the controls to OFF, and remove plug
from the socket-outlet.
Note: Do not force knob beyond its normal stop position.
MAINTENANCE
1. Always remove the plug from the socket-outlet and allow the heater to cool down
before clean it.
2. Wipe the exterior surface of the heater occasionally with a soft damp cloth (not
dripping wet) and dry the exterior surface before operating the heater.
WARNING:
Do not immerse the heater in water.
Do not use any cleaning chemicals such as detergents and abrasives.
Do not allow the interior to get wet as this could create a hazard.
3. Light accumulated may be removed from the heater with a soft dry cloth.
4. To store away the heater, put the heater back into its original package and store it
in a clean dry place.
5. In case of malfunction or doubt, do not try to repair the heater yourself, it may result
in a fire hazard or electric shock.
CONFORMITY WITH DIRECTIVES
This product is CE marked to denote conformity with Directives 2006/95/EC (Low
Voltage) and 89/336/EEC (Electromagnetic Compatibility), as amended.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To
return your used device, please use the return and collection systems or
contact the retailer where the product was purchased. They can take this
product for environmental safe recycling.
Warranty Information
The manufacturer provides warranty in accordance with the legislation of the

customer's own country of residence, with a minimum of 1 year (Germany: 2
years), starting from the date on which the appliance is sold to the end user.
The warranty only covers defects in material or workmanship.
The repairs under warranty may only be carried out by an authorized service
centre. When making a claim under the warranty, the original bill of purchase
(with purchase date) must be submitted.
The warranty will not apply in cases of:
- Normal wear and tear
- Incorrect use, e.g. overloading of the appliance, use of non-approved
accessories
- Use of force, damage caused by external influences
- Damage caused by non-observance of the user manual, e.g. connection to an
unsuitable mains supply or non-compliance with the installation instructions
- Partially or completely dismantled appliances