Summer 2008 33
Dual Side Burner/Griddle Dimensions
(with optional grill cart)
Dual Side Burner/Griddle Model: BFG-30BGD
Cart Model: CAD-30 (shown with optional side shelves)
Dual Side Burner/Griddle
Island Preparation
Dual Side Burner/Griddle Model: BFG-30BGD
Weencourage you to find out moreabout these features and learnhow they
can make your cooking experience more enjoyable by visiting our learning
page at: www.dcsappliances.com.
Because of continuing product improvement these specifications are subject
to change without notice.
MODEL NUMBER BFG-30BGD
GRIDDLE 12,000 BTU/HR
SIDE BURNERS 2 @ 17,000 BTU/HR
SHIPPING WEIGHT (SIDE BURNER/GRIDDLE HEAD) 120 LBS.
SHIPPING WEIGHT (OPTIONAL CART) 120 LBS.
SHIPPING DIMENSIONS
Ordering Data:
Please specify gas type (natural or propane) when ordering
Gas Requirements:
Natural
•1/2" NPT male with a 3/8" flareadapter
•Operational Pressure: 4” W.C.
•Supply Pressure: 6" to 9” W.C.
Propane
•1/2" NPT male with a 3/8" flareadapter
•LP hose with a quick disconnect & fitting are shipped
connected
•Operational Pressure: 11” W.C.
•Supply Pressure: 11" to 14” W.C.
Power Requirements:
•9V battery
Island Ventilation Requirements:
It is recommended that adequate ventilation holes must be
provided in the base of an enclosure in the event of a gas leak.
Side burner/Griddle Placement:
DO NOT build side burner/griddle under overhead unprotected
combustible construction. Use only in well-ventilated areas.
These units are for outdoor use only. If located in a consistently
windy area (oceanfront, mountaintop, etc.) a wind break will be
required.
Conversion Kits:
NG to LP and LP to NG conversion kits areavailable from your
dealer.
Accessories
•Stainless Steel Grill Cart(CAD-30)
•Single or double side burners for built-in application
•Stainless Steel Access Doors for built-in application
•Stainless Steel Access Drawers for built-in application
•Insulated Jacket for built-in application
•Brazilian Cherry Chopping Board that fits in cart optional
side-shelf
• Vinyl Grill Cover
•Wok and Wok Ring for use on side burners
access doors
(ADN20x30)
access drawer
(ADR30)
Vent
#
4” x 4” opening for
gas supply line
3” to non-combustible
construction and
12” min. combustible
construction
*Standardcut-out dimensions for non-combustible enclosure
** Insulated jacket cut-out dimensions for combustible enclosure
#Island installation to use minimum of 3 vents providing
10 square inches per vent (typical)
Vent
#
Vent
#
32” X 32” X 16”
(SIDE BURNER/GRIDDLE HEAD) (HEIGHT X WIDTH X DEPTH)