Pit Boss PB2BGT1 Manual

 480 9239630
   18779422246
.
Included Parts: (1) Lid, (2) Hinges x2 , (3) Left Top Hinge,
(4) Right Top Hinge, (5) Lid Handle Bezel x2, (6) Lid
Handle
Remove the two screws from the back of the firebox
that holds the burners in place.
First, install the Left Top Hinge with the pre-installed
screws, locking washers, and washers. Slide the hinge
pin into the lower hinge on the firebox base.
Remove the griddle cooking surface and place aside.
Place the hinge on the back edge of the firebox
at a 90° angle and rotate down to line it up to the
screw holes from the burners. Screw the hinges and
burners in place with the screws, locking washers, and
washers.
First, slide the Right Top Hinge pin into the lower
hinge on the firebox base. Then secure the Right Top
Hinge with the pre-installed screws, locking washers,
and washers.
 
21  
 41052
1
3
5
2
4
6
1
*  
2
4
3
5
6
1
2 2
1
602221110UMV
©2022 DANSONS

/ 480 9239630
  /  18779422246
.
602221110UMV
©2022 DANSONS
Remove the pre-installed screws from the handle.
Place the lid handle bezels between the handle and
lid. Secure them into place with the screws.
The Griddle Lid is fully installed.
Place the griddle cooking surface on top of the
firebox.
7
9
8