decina FREESTANDING SPA BATH User manual

FREESTANDING SPA BATH INSTALLATION & OWNER GUIDE
Manufactured from premium sanitary grade acrylic, Decina’s freestanding spa baths are easy to install, with adjustable self-supporting feet &
can be freely located anywhere in your bathroom. This manual provides the correct steps & care advice for a safe & long lasting installation.
THIS PRODUCT MUST BE INSTALLED BY A QUALIFIED TRADESMAN
READ CAREFULLY
PRIOR TO COMMENCING
INSTALLATION...
PRE-INSTALLATION CHECKS
!Unpack & check the item is correct & no damage has occurred during transit.
!If there are any visible defects DO NOT PROCEED WITH THE INSTALLATION &please contact the place of purchase immediately.
ANY CLAIMS FOR DAMAGE WILL NOT BE ACCEPTED AFTER INSTALLATION.
!Protect your spa bath before & during installation, scratches &/or cracks &/or surface damage sustained during or after the
installation are not covered by warranty.
!Installation must be in accordance with building regulations & local authority requirements.
!Electrical installation must comply with AS:3000 - Electrical Wiring Rules.
CARING FOR YOUR SPA BATH
DECINA USES THE HIGHEST SANITARY GRADE ACRYLIC, HOWEVER NAKED FLAMES, CIGARETTES OR STRONG CHEMICALS
SHOULD BE AVOID & REMOVED IMMEDIANTLY. TO PRESERVE THE HIGH GLOSS ACRYLIC SURFACE:
!When filling the spa bath start with cold water to allow the bath to gradually adapt to the temperature.
!After using your spa bath clean with a soft cloth & warm soapy water to clean any oils or soap, to prevent tide marks &
preserve the polished surface.
!Clean using warm soapy water & only mild liquid detergents. Do not use powders, pastes, creams, chemicals, window cleaning
sprays or abrasive cleaners.
!Cream cleaners may only BE USED to remove stubborn marks.
!Scratches can be removed with a fine polish like Brasso.

1. Remove your freestanding spa bath from the carton & place it in the correct position for installation. Check for damage &
ensure your spa bath does not come in contact with any rough surfaces which may scratch your bath. Place it on cardboard or
carpet during installation.
2. Turn the self-leveling feet so the bath base is level & 3-5mm
above the finished floor.
A) Ensure there is a gap of 3-5mm between the bath shell & the
floor. Installing the bath shell directly onto the bath floor will place
pressure on the outside wall of the bath & can crack the bath.
B) Ensure the bath is level so all the water can drain to the
waste outlet.
3. Your freestanding spa bath is supplied fully plumbed & with
a 10AMP, 50HZ, 240V pump fitted with a 3-pin Power Plug.
Your freestanding spa bath will be required to either be
hardwired or plugged into a suitable power point.
For further guidance on the location of the power point &
any other electrical requirements, please discuss with your
licensed electrician.
4. Carefully tilt the spa bath on its side & connect it to the drain
outlet. We recommend using a Decina Flexible Connector.
Ensure the Flexible Connector is cut to the correct length for
easier installation & to prevent drainage issues.
5. Electrically connect your spa bath based on your electricians
directions.
6. Before finishing, water test for leaks & correct drainage.
A) Fill the freestanding spa bath with water & check the water
flows easily to the waste outlet.
NOTE a small amount of water may pool due to surface tension.
7. Apply a thick bead of silicon around the spa bath base & the
finished floor & allow it to set for 24 hours.
INSTALLATION STEPS
All dimensions are nominal & subject to manufacturing tolerances & may vary +/-5mm therefore we strongly recommend installation does not occur until after delivery. Decina reserves the right
to modify or change models without notice. For further information and for warranty T&C’s, please visit decina.com.au or call 1300 332 462.
1300 DECINADECINA.COM.AU
WARRANTY TERMS & CONDITIONS
All Decina products are manufactured to the highest standards and guaranteed to be free of defects, subject to the conditions outlined
below. In addition to the statutory rights given under Australian Consumer Law, Decina offers the following extended warranty periods
from the date of purchase or handover:
PRODUCT WARRANTY TERMS
FREESTANDING SPA BATH - Shell, Frame & Pipe Work 10 Years / 1 Year Replacement Products / Parts & Labour
FREESTANDING SPA BATH - Pump, Jets & Fittings 5 Years / 1 Year Replacement Products / Parts & Labour
For full warranty terms & conditions, please visit the Decina website decina.com.au/warranty
To make a warranty claim, please visit the Decina website decina.com.au/warranty-claim/ or email [email protected]om.au
PLEASE LEAVE THIS MANUAL WITH THE END USER. Copyright Oct 2019. Decina Bathroomware Pty Ltd. ABN 39845 084 033.
Decina Flexible Connector + Pop-Up Waste OWA004 Min. clearance 100mm
Decina Flexible Connector OWA005 Min. clearance 80mm
Drain
Waste Outlet Flexible Connector
3-5mm