deerma DEM-CF15W User manual

INSTRUCTION
MANUAL
HAIR DRYER
DEM-CF15W
Read all instructions before using and save these instructions
In addition, this instruction can be available on the following website:
http://www.deerma.com

Product structure
1.Outlet
2.Body
3.Inlet
4. Cool shot button
5.ON/OFF button
6.Handle
7.Bushing
8.Power cord
Product Parameters
Product Model: DEM-CF15W
Rated Power: 1600-2000W
Rated Voltage: 220-240V~
Rated Frequency: 50-60Hz
Important Safeguards
When using an electrical appliance, basic safety precautions should
always be observed, including the following:
1. Check if the voltage indicated on the appliance corresponds to the
local voltage before you connect the appliance.
2. This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of expe-
rience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not play with the
appliance.

3. WARNING – Do not use this appliance near water or in
bathtubs, basins or other vessels.
4. When the hair dryer is used in a bathroom, unplug the appliance
after use since the proximity of water presents a hazard, even when the
hairdryer is switched off.
5. For additional protection, we advise you to install a residual current
device (RCD) with a rated residual operating current not exceeding
30mA in the electrical circuit supplying the bathroom. Ask your instal-
ler for advice.
6. Never block the air grilles.
7. If the appliance overheats, it will switch off automatically. Unplug the
appliance and let it cool down for a few minutes. Before you switch the
appliance on again, check the grilles to make sure they are not blocked
by fluff, hair, etc.
8. Do not direct the airflow towards the eyes or other sensitive areas.
9. Neither should the appliance be used with wet hands nor immersed
in water, held in running water, or allowed to become wet.
10. Do not use the hair dryer for purposes other than drying and styling
human hair.
11. Do not pull the cord with unnecessary force. Do not wrap the cord
around the unit. Check cord regularly for any sign of damage. Dama-
ged cords can be dangerous.
12.If the supply cord is damaged, it must be replaced by the manufac-
turer or its service agent or a similarly qualified person in order to avoid
a hazard.
13. Always unplug the appliance after use. When the product is con-
nected to the power supply, do not leave it unattended, and be sure to
unplug the product after use.
14. Clean the appliance after use to avoid the accumulation of grease
and other residues.
Drying
1. Put the plug in the wall socket.
2. Switch the appliance on by selecting the desired setting.
The airflow and temperature can be adjusted:
Dry your hair by making brushing movements while holding the dryer
at a small distance from your hair.
For DEM-CF15W
0: appliance off
Cool wind
I : low speed & low heating
II : high-speed & high heating

Styling attachments
（1）Concentrator
The concentrator enables you to direct the airflow at your hair that you
are styling.
Connect the concentrator by simply snapping it onto the appliance.
Disconnect it by pulling it off.
Cleaning &Storage
1. After use, immediately turn off the power switch and unplug the
power plug.
2. The appliance can be cleaned with a dry cloth.
3. The attachments can be cleaned with a moist cloth or rinsed under
a running tap.
4. Remove the attachments from the appliance before cleaning them.
Make sure the attachments are dry before using or storing them.
5. Never rinse the appliance with water.
6. Allow the appliance to cool and store it in a dry location.
7. Never wrap the cord around the appliance since this will cause the
cord to wear prematurely and break.
8. If the supply cord of this appliance becomes damaged the appliance
must be replaced by returning to the retailer from which the product
was purchased or a similarly qualified person in order to avoid a
hazard.
Troubleshooting of fault during use
Fault Cause Troubleshooting
Product
failure to work
The power socket of the
product is not energized.
Check whether the power
socket is in good contact.
The product is powered
off automatically due to
overheating.
Unplug the power plug and let the
product cool for a few minutes.
Before powering on the product
again, please check the air outlet
to make sure it is not blocked by
lint, hair and other debris.
The voltage of power supply
connected to the product is
inconsistent with the rated
voltage of the product.
Ensure that the voltage of local
power supply is consistent with
the voltage indicated on the
product model nameplate.

Correct Disposal of this product
This marking indicates that this product should not be disposed with other house-
hold wastes throughout the EU. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, recycle it responsibly to promote
the sustainable reuse of material resources. To return your used device, please use
the return and collection systems or contact the retailer where the product was
purchased. They can take this product for environmental safe recycling.