Vitek VT-2327 CL User manual

1
VT-2327 CL
3
6
10
13
17
21
Hair dryer
Фен
VT-2327.indd 1 20.02.2015 14:51:37

VT-2327.indd 2 20.02.2015 14:51:37

3
E N G L I S H
HAIR DRYER VT-2327 CL
The hairdryer is intended for hair drying and
styling.
DESCRIPTION
1. Air supply speed switch (0/ / )
2. Heating degree switch ( / / )
3. Cool shot button
4. Nozzle
5. Air inlet grid (removable filter)
6. Handle
7. Hanging loop
8. Diffuser
ATTENTION!
– Do not use the unit near containers filled with
water (such as bath, swimming pool etc.).
– After using the hairdryer in a bathroom, pull
the plug out of the mains socket immediately,
as water closeness is dangerous even if the
unit is switched off.
– For additional protection you can install a
residual current device (RCD) with nominal
operation current not exceeding 30 mA into
the bathroom mains; contact a specialist for
installation.
SAFETY MEASURES
Before using the unit, read this instruction man-
ual carefully and keep it for future reference.
Use the unit according to its intended purpose
only, as it is stated in this user manual. Mishandling
the unit can lead to its breakage and cause harm
to the user or damage to his/her property.
•Before switching the unit on, make sure that
your home mains voltage corresponds to the
unit operating voltage.
•To avoid fire, do not use adapters for connect-
ing the unit to the mains.
•Use only the attachment supplied with the unit.
•When using the unit, we recommend to
unwind the power cord to its full length.
•The power cord should not:
– touch hot objects,
– run over sharp edges,
– be used for carrying the unit.
•Check the power cord and power plug insula-
tion integrity periodically.
•Do not switch the unit on in places where
aerosols are sprayed or highly inflammable
liquids are used.
•Hair spray should be applied only after hair
styling is finished.
•Do not operate the unit while taking a bath.
•Never leave the operating unit unattended.
•Do not touch the unit body, the power cord
and the power plug with wet hands.
•Take the switched on hairdryer by its handle
only.
•Do not place and do not keep the unit in
places where it can fall into a bath or a sink,
filled with water, do not immerse the unit into
water or other liquids.
•If the unit is dropped into water, unplug it
immediately. And only then take it out of water.
•Do not use the unit when you are drowsy.
•Do not use the unit to style wet hair or syn-
thetic wigs.
•Avoid contact of heated surfaces with your
face, neck and other parts of your body.
•Do not drop the unit.
•During operation do not put the unit on heat-
sensitive surfaces, soft surfaces (bed or sofa)
and do not cover it.
•Do not direct hot air at your eyes or other
heat-sensitive parts of your body.
•The nozzle gets hot during operation. Let it
cool down before removal.
•Never insert any foreign objects into the unit
body openings.
•Never block the air inlets of the hairdryer, do
not place it on a soft surface, such as bed
or sofa, where the air inlets may be blocked.
Keep the air inlets free of lint, dust, hair etc.
•Avoid getting of hair into the air inlet grid dur-
ing operation of the unit.
•Unplug the unit after every usage and before
cleaning.
•When unplugging the unit, pull the plug but
not the power cord.
•For children safety reasons do not leave poly-
ethylene bags, used as a packaging, unat-
tended.
•Attention! Do not allow children to play with
polyethylene bags or packaging film. Danger
of suffocation!
•Do not allow children under 8 years of age to
touch the unit body, the power cord and the
power plug during operation of the unit.
•Do not leave children unattended to pre-
vent using the unit as a toy.
•Close supervision is necessary when children
under 8 years of age or disabled persons are
near the operating unit.
•This unit is not intended for usage by children
under 8 years of age.
VT-2327.indd 3 20.02.2015 14:51:38

4
ENGLISH
•Children aged 8 and over as well as disabled
persons can use this unit only under supervi-
sion of a person who is responsible for their
safety, if they are given all the necessary and
understandable instructions concerning the
safe usage of the unit and information about
danger that can be caused by its improper
usage.
•To avoid damages, transport the unit in origi-
nal package only.
•Never use the unit if the power cord or the
plug is damaged, if the unit works improperly
or after it was dropped. Do not try to repair the
unit by yourself. Contact an authorized ser-
vice center for all repair issues.
Keep the unit in a dry cool place out of reach
of children and disabled persons.
THE UNIT IS INTENDED FOR HOUSEHOLD
USAGE ONLY
USING THE HAIRDRYER
After unit transportation or storage under
cold (winter) conditions, it is necessary to
keep it for at least two hours at room tem-
perature before switching on.
– Before switching the unit on, make sure that
your home mains voltage corresponds to unit
operating voltage.
– Remove any stickers that can prevent unit
operation.
– Unwind the power cord completely.
– Insert the power plug into the mains socket.
– Use the switch (1) to set the required air sup-
ply speed:
«0» – the hairdryer is off;
«» – low speed;
«» – high speed.
– Use the switch (2) to set the required temper-
ature of the air flow:
«» – low heating;
«» – medium heating;
«» – maximal heating.
Note: During the first operation some for-
eign smell and a small amount of smoke
from the heating element is possible, this
is normal.
– This model has a cool shot function, use it to
fix your hairstyle. To make a cool shot switch
the hairdryer on, then press and hold the but-
ton (3) .
Hair care
To get the best results, wash your hair with sham-
poo, remove excessive moisture with a towel and
comb your hair, then start drying and styling it.
Quick drying
Set the switch (2) to maximal heating position
«», select the required air supply speed using the
switch (1) and dry your hair. Shake excessive mois-
ture off your hair with your hand or a comb and con-
stantly move the hairdryer above your hair.
Straightening
Set the switch (2) to maximal heating position
«», select the required air supply speed using
the switch (1) and dry your hair. When the hair
is almost dry, switch the unit off, set the noz-
zle (4), decrease the heating degree using the
switch (2) and reduce the air flow speed using
the switch (1).
Divide your hair into locks, start straightening
from lower layers. Using a plain or round brush,
comb your hair from top to bottom and simul-
taneously direct hot air from the nozzle (4) at
it. Slowly straighten each lock from root to end
this way. After you finish straightening the lower
locks, start to straighten the locks of the middle
layer and finish with locks of the upper hair layer.
Natural wavy hairstyle
Set the switch (2) to the low heating position
«», select the low air supply speed by setting the
switch (1) to the position « », grip locks between
fingers, turn them in the direction of natural curl-
ing. Dry your hair, directing the airflow at the
area between fingers. Once the required effect is
achieved, press and hold the cool shot button (3)
and fix each lock.
Styling
Install the nozzle (4) in the hairdryer and then set
the switches (2) and (1) to the low heating/speed
position « »/« ».
Divide your hair into locks and style your hair with
a round styling brush. During styling, direct the
air flow straight at your hair.
If you want to fix the hairstyle, direct the cool
shot at each lock for 2-5 seconds. Styling time
depends on hair type; choose it by yourself.
Using the diffuser (8)
The air flow dispersed by diffuser provides soft
drying and adds volume to your hair. Special «fin-
VT-2327.indd 4 20.02.2015 14:51:38

5
E N G L I S H
gers» volumize your hairstyle. Direct the air flow
at the hair roots.
Overheating protection
Overheating protection switches the hairdryer
off if the outgoing air is too hot. If the hair-
dryer switches off during operation, set the
switch (1) to the «0» position, unplug the hair-
dryer and make sure that the inlets and outlets
are unblocked. Let the hairdryer cool down for
5–10 minutes and switch it on again. Do not block
the air inlets during unit operation and avoid get-
ting of hair into its air inlet.
CLEANING AND CARE
The hairdryer is intended for household usage
only.
1. Set the switch (1) to the «0» position and
unplug the hairdryer.
2. Wipe the unit body with a damp cloth and then
wipe it dry.
3. Turn the grid (5) counterclockwise and
remove it from the unit body. Clean the grid
(5) with a brush and install the grid (5) back
to its place.
4. Never immerse the unit into water or other
liquids.
5. Do not use abrasives and solvents to clean
the unit body.
STORAGE
– Unplug the hairdryer if you are not using it.
– Let the unit cool down after using it and keep
it in a dry cool place out of reach of children.
– Never wind the power cord around the hair-
dryer, as this can damage the cord. Handle
the power cord with care, do not pull, twist
or stretch it, especially near the power plug
or at the junction point. Straighten the cord
periodically if it gets twisted during ope-
ration.
– For easy storage there is a hanging loop (7),
you can hang the unit on this loop provided
that no water gets on the unit in this position.
DELIVERY SET
Hairdryer – 1 pc.
Nozzle – 1 pc.
Diffuser – 1 pc.
Instruction manual – 1 pc.
TECHNICAL SPECIFICATIONS
Power supply: 220–240 V ~ 50 Hz
Power consumption: 1800-2200 W
The manufacturer preserves the right to change
the specifications of the unit without a prelimi-
nary notification.
Unit operating life is 3 years
Guarantee
Details regarding guarantee conditions can be
obtained from the dealer from whom the appli-
ance was purchased. The bill of sale or receipt
must be produced when making any claim under
the terms of this guarantee.
This product conforms to the EMC-
Requirements as laid down by the Council
Directive 2004/108/ЕС and to the Low
Voltage Regulation (2006/95/ЕС)
VT-2327.indd 5 20.02.2015 14:51:38