DeeZee DZ 43200 User manual

PARTS LIST:
ITEM
QTY
THREAD LOCK TUBE 1
SHOCK 1
BALL MOUNT PLATE 1
NUTSERT TOOL 1
BALL MOUNT 1
NUTSERT 1
TORX WRENCH 1
TOOLS REQUIRED:
T-50 TORX
M5 ALLEN WRENCH
TAPE MEASURE
10MM WRENCH
13MM WRENCH
DZ 43200
TAIL ATE ASSIST
FORD F-150 2004-2011
13MM WRENCH
STEP 1)
STEP 2)
STEP 3)
Adjust the nutsert tool so
Using a M5 Allen wrench and
Mark one side of the nut and
Apply thread lock to the threads
there is 3/4" from the washer
a 10mm wrench, install the
count the number of revolutions
of the ball mount.
to the head of the bolt.
nutsert in the opening by the
to insure the correct number
Install the ball mount into the
tailgate pivot point.
of full turns.
nutsert using a 13mm
Overtightening the nutsert
wrench/socket.
can strip the threads and cause
the nutsert to be unusable.
Remove the nutsert tool
when installation is complete.
The nutsert should NOT be
tightened any more than 9
360 degree turns.

STEP 4)
STEP 5)
STEP 6)
STEP 7)
Use a T50 torx socket or the
Install the bolt removed from
Install the cable back onto
Install the narrow end of the
wrench provided to remove the
the previous step through the
the cable bolt, and the
shock on the ball mount
cable bolt. Remove the tailgate
hole in the ball mount plate back
larger part of the shock
previously installed.
cable from the bolt.
into the hole.
on the ball mount.
Tighten the bolt with the T50.