Deltenna Wibe hs21 User manual

1. SIM

Insert a SIM with contacts facing

the back of the WiBE®

2. POWER

Insert the power lead and plug it

into an easily accessible socket

3. POSITION

Place the WiBE®high and with a

good line of site (e.g near a

window)

4. ETHERNET/WIFI

Connect to the WiBE®via a Cabled

(Ethernet) or a Wireless (WiFi) LAN

5. CONNECT

Located on the base of the WiBE®

you’ll ﬁnd the following:

SSID: WiBE-XXXX

WPA: XXXXXXXX

URL: 192.168.1.1

Username: admin

Password: XXXXXXXXX

WARRANTY

1. This product is warranted for 12 (Twelve)

months from the date of purchase.

2. The product will be repaired or replaced

free of charge by local Authorised Service

Centres, if, at their sole discretion, it is found

to be faulty within the warranty period.

3. This warranty only applies to products sold

and distributed within approved countries by

Deltenna and its authorised distributors

and/or retail outlets.

4. This warranty only applies if the product

has been used in accordance with the

manufacturer's instructions under normal

use and with reasonable care.

5. What this warranty does not cover:

a) Defects or damage resulting from the

misuse of this product.

b) Defects or damage from abnormal use,

abnormal conditions, improper storage,

exposure to moisture, dampness or corrosive

environments, unauthorised modiﬁcations,

unauthorised repair, neglect, rough handling,

abuse, accident, alteration, improper

installation, incorrect voltage application, food

or liquid spillage, acts of God.

c) Normal wear and tear.

d) If the product has been opened, modiﬁed

or repaired by anyone other than an

Authorised Service Centre or if it is repaired

using unauthorised spare parts.

e) If the serial number has been removed,

erased, defaced, altered or is illegible in any

way.

LIMITED WARRANTY

To the extent permitted by applicable law, this

limited warranty is your sole and exclusive

remedy against Deltenna and Deltenna’s sole

and exclusive liability in respect of defects in

product. However, this limited warranty shall

not exclude nor limit any of your legal

(statutory) rights under the applicable

national laws. To the extent permitted by

applicable law Deltenna does not assume any

liability for loss of or damage to or corruption

of data, for any loss of proﬁt, loss of use of

products or functionality, loss of business,

loss of revenues or loss of anticipated proﬁt,

increased cost or expenses or for any

indirect, or special or consequential loss or

damage. To the extent permitted by

applicable law, Deltenna’s liability shall be

limited to the purchase value of the product.

The above limitations shall not apply to death

or personal injury caused by defect of

product in material, design and workmanship.

Quick Start Guide

WiBE®is a registered trade mark of Deltenna Limited

Class 2 equipment, for use in: AT BE BG CY CZ DK EE FI FR DE GR HU IS IE IT LV LT LU MT NL

NO PL PT RO SK SI ES SE CH GB

Hereby Deltenna Limited declares that the WiBE®HS21 is in compliance with the essential

requirements and other provisions of Directive 1999/5/ EC.

Name

Power

WiFi

Antenna

Icon Description

Indicates WiBE®is connected to mains electricity

ON = Ready to use FLASH = Data traﬃc

ON = Connected FLASH = 3G problem

ON = Connected FLASH = Searching

Name

1. Power Connector

2. Factory Reset

3. LAN (Ethernet)

4. LAN Light

Description

Insert power lead (6V)

Use pen or paperclip to hold in for 15 seconds

Connection points

ON = Connected FLASH = Data traﬃc

TROUBLE SHOOTING

If the power light is not on, then the WiBE®is not connected to the mains. Only use WiBE®power adaptor, model SAW-0601600.

The WiFi light should come on within a minute of plugging the WiBE®in. If it does not then there is likely to be a fault with the WiBE®.

The antenna lights will ﬂash to show that the WiBE®is searching for the best 3G connection. This process should take less than 5 minutes from the power

light coming on.

The 3G light will only come on if the WiBE®can connect to a 3G network. For this to happen it must be in range of a 3G network. It can take several

minutes for the WiBE® to detect a network providers APN conﬁguration details the ﬁrst time a new SIM is inserted. If the 3G light ﬂashes quickly there is a

problem with the SIM/3G connection. Note that the WiBE®only connects to a 3G network . It will not connect to a 2G network if 3G is not available.

When the WiBE®has succeeded in connecting to a 3G network, the 3G light will be on and one of the antenna lights will show which antenna the WiBE®is

using. If one antenna light is on and another is ﬂashing, the connection is OK, but it may get a better data speed if the WiBE® is moved to a diﬀerent side of

the building.