Denfit StreetWorkout Bootcamp special User manual

Installation of Denfit StreetWorkout on
concrete
On concrete (installation on tarmac is not possible)
Remarks:
1 - Make sure that the concrete floor is strong enough to install the StreetWorkout unit. It has to be
reinforced concrete.
The Street Workout units are provided with a round foot plate Ø 185 or Ø 100 mm, and they have
got 4 anchoring holes. Always use the drawing of the products to determine the centre to centre
distances.
1
2
3
4
5
6
1 —Put the unit on a flat concrete floor and mark the holes.
2 —Drill the marked holes. See note.
3 —Clean the holes with air
4 —Apply the chemical anchoring in the holes. See note.
5 —Put the rods with internal thread M16 in the holes. See note.
6 —Put the footplate with the holes above the rods and fasten the bolts halfway
7 –After the bars are installed (see next page) and the posts are level, fasten the bolts into the concrete
Note: the drill diameter and the threaded rods can vary by manufacturer.

2
Make sure that the concrete floor is strong enough to install the Streetworkout unit. It has to be
reinforced concrete of at least 140 mm thickness and it has to be one compact concrete floor (and
not small concrete plates).

3
2 - The posts, bars and tubes on the posts are labelled:
The numbers on the bars and tubes match with each other. Make sure you connect the same
numbers.
3 - When the bar is installed between the posts screw in the security bolt halfway by hand. Then do
the adjustments and make sure that the posts are completely level.
4 - Tighten the security bolts of the bars completely when the posts are level. Use Loctite!
5 - Only then fasten the bolts into the concrete.