Denon DVD-2500BT User manual

Erstelldatum 29.08.2008 14:45:00
Seite 1 von 3
DVD-2500BT
BEFORE APPLYING THE UPDATE PLEASE ENSURE YOU HAVE READ AND
FULLY UNDERSTAND THESE INSTRUCTIONS.
Reproduction, publication in electrical or any other from of this software and its documentation
without the express written consent of the rightful owner is forbidden and will be prosecuted by law.
© 2008 DENON UK
Warnung:
Warning:
Please read though these instructions completely before attempting to update your player. The use of this update is
completely at the owner’s risk. DENON can not be held accountable for damage resulting to the player or
associated equipment as a result of improper use of this update.
During the upgrade process it is imperative that you do not switch off the unit's power and/or press any of the
buttons on the unit or remote control unless otherwise instructed.
Nr. Description Note
1.
If you have not done so already, please connect
the DVD-2500BT to a monitor using the HDMI
connections (Page 10 of the user manual
2. Turn on the player and monitor.
3.
Please ensure that you do not have any discs
currently inside the player and the draw is
closed.
4.
To put the BD player into version up mode,
press quickly on enclosed RC-1091 following
buttons on the remote control unit in that order:
[9], [8],[7],[6] und [POP UP MENU/ MENU]
5. The tray will open automatically.
6. Following message appears on the screen Æ

Erstelldatum 29.08.2008 14:45:00
Seite 2 von 3
7. On unit’s display appears following message Æ[F/W- UP]
8.
Load the disc for version up and close the tray
by means of button OPEN/CLOSE () on the
unit.
firmware file: E5J01ED1108DB2.bin
9. Following message appears on the screen Æ
10. The unit reads firmware out of inserted CD- ROM.
This Step takes about 3 minutes.
11. Once the unit has completely read the firmware
tray opens automatically.
12. On unit’s display appears following message Æ
[Ver: 1108]
13.
Take out the CD-R out of the tray and close it
by means of button OPEN/CLOSE () on the
unit.
14.
After the tray has been closed the firmware is
being written into the EEPROM of the player.
The progress of this step is shown on the unit’s
display.(eg.) Æ
[0%~100%]
This Step takes about 2 minutes.

Erstelldatum 29.08.2008 14:45:00
Seite 3 von 3
15.
During the update process it is imperative
that you do not switch off the unit's power
and/or press any of the buttons on the unit or
remote control unless otherwise instructed.
16. After programming* is finished, the checksum is indicated on the unit’s display Æ
[57E9]
* At this time, no button is available.
17. Once the checksum has been shown the update procedure is completed.
18. Unplug the AC cord from the AC outlet.
Then plug it again.
19. Turn the power on by pressing the
[POWER ON] button.
20. In order to verify new firmware version please
repeat Steps 4, 18 and 19.
Notes:
Your player’s settings will have been returned to their factory defaults.
Please re-configure the player (according User manual ) to your requirements. Denon do not advise the
loading of any non-official firmware into your DVD player. Doing so could compromise the features and
performance of your player.
© 2008 DENON UK Moorbridge House, Padbury Oaks
579 Bath Road, Longford, Middlesex, UB7 0EW.
All rights reserved.