Detox HK-809 User manual

FOOT SPA
Please keep this manual for future use.

- 2 -
PARTS LIST
OPERATING INSTRUCTIONS
1. Connect the main frame to the power source, and then connect the
parts we provide to the main frame. Make sure that put the fixture in
a dry and stable place.
2. Turn on the machine by pressing down the power button on the
back side of the main frame.
3. Put the arrays into your basin. The water level should completely
submerge the array.
4. It is recommended that add about 0.1g sea salt to the bath water
to enhance ionic conduction.
5. Press the corresponding touch key to start the desired working
mode.

- 3 -
PANEL INSTRUCTIONS
Start the Working Cycle
Stop the Working Cycle
Time Decreasing Button
Time Increasing Button
Mode Switching Button
Volt Amperage
High Intensity
Medium Intensity
Low Intensity
Intensity Switching Button
FIR Belt Port
Power Interface
Power Switch

- 4 -
MODE INSTRUCTIONS
Mode 1 All positive polarity, expelling acid substance and raising PH
levels.
Mode 1 is the default mode whose setting time is 30 minutes. The
maximum working cycle is 60 minutes. However, 30-minute-session is
suitable for most of the people.
Mode 2 All negative polarity, expelling heavy metals and lowering PH
levels.

- 5 -
Mode 3 (70%+)(30%-)Expelling acid substance as well as heavy metals
and raising PH levels. Mode 3 is the most popular mode which is
suitable for most people.
Mode 4 (15%+)(15%-)(5%-)Expelling acid substance as well as heavy
metals and raising PH levels.
Mode 5 (10%-)(15%+)(5%-)Expelling heavy metals as well as acid
substance and maintaining a stale PH level.

- 6 -
TROUBLESHOOTING
SYMPTOM
POSSIBLE CAUSE
ACTION NEEDED
No values displayed on the screen
The Wrist Band enters
protection mode
Unplug the machine and reboot it.
Press the STOP button and then
START button twice. The screen will
display values and reboot the wrist
band function.
Black Screen/the screen only
displays zero
The power supply is not
connected
Check if the power is plugged in.
Fuse burned out
Replace the fuse.
The power switch is not
turned on
Turn on the power source.
The machine stops working
The array is not
connected.
Check if the array is plugged in
The array is broken.
Replace the array.
NOTE
It should never be used by people who are:
Using a peacemaker;
With a heart condition or epilepsy;
Pregnant.
SPECIFICATION
Item No.: HK-809 Max Power: 60W
Frequency: 50Hz-60Hz Electric Current: 0-2.5A
Input Power: AC110V-230V Out Power: 0-15V.